Loading ...
Loading ...
Loading ...
7
1886
Ceiling Bracket Hanging Fan Wiring Canopy Blades Light Bulbs Remote
Assembling the Hood
WARNING
FAN FALL HAZARD
Make sure the hood is securely attached to the
mounting plate. Failure to properly secure all
3 assembly screws could result in the switch
housing xture falling.
Connect the plugs from the fan and lower switch
housing. Make sure to line up the colored markings
on the connectors.
Screw two housing assembly screws from the
hardware bag halfway into the motor housing. It
does not matter which two screw holes you choose.
Install the lower switch housing to the hood using
the three pre-installed capture screws. Tighten all
three screws.
Feed the wire plug through the center hole of the
hood, then wrap keyhole slots around the screws
and twist counterclockwise.
Install the bulb into the socket. When necessary,
replace with bulb of the same type and wattage.
Insert the third screw, found in the hardware
bag, into place and then tighten all three screws.
PRESS
DOWN
FIRMLY
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
Remove the top liner of the three adhesive strips afxed to the lip of
the interior hood.
P
E
E
L
x
3
2 of 3
PRE-INSTALLED
Loading ...
Loading ...
Loading ...