Loading ...
Loading ...
Loading ...
12
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the rower is used. Replace
any worn parts immediately.
To clean the rower, use a damp cloth and a small
amount of mild detergent. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
For best results, clean the rail, the seat carriage, and
the carriage rollers daily.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries;
for replacement instructions, see assembly step 6 on
page 7.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the
resistance handle and the right and left shields as
described below.
First, remove the
six M4 x 10mm
Screws (70),
and then gen-
tly remove the
Resistance
Handle (9).
See the EXPLODED DRAWING on page 15.
Locate the Right and Left Shields (7, 8), and remove
the four M4 x 19mm Screws (69) and the ten
M4 x 16mm Screws (68) from the Right and Left
Shields. Then, gently remove the Right and Left
Shields.
Then, locate the Reed Switch (47). Turn the Left
Fan (4) until a Magnet (77) is aligned with the Reed
Switch. Loosen, but do not remove, the two indi-
cated M4 x 19mm Screws (69). Then, slide the Reed
Switch slightly closer to or away from the Magnet, and
retighten the Screws.
Turn the Left Fan (4) so that the Magnet (77) passes
the Reed Switch (47) repeatedly. Repeat these actions
until the console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the parts that you removed.
70
70
9
4
69
77
47
MAINTENANCE AND TROUBLESHOOTING
Loading ...
Loading ...
Loading ...