Loading ...
Loading ...
Loading ...
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1 Open the door (top controls only) and pressthe [On/Off] button.
2 Press the [+] button until the display jumps to "h:01"
3 Press the [÷] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4 Press [Start] to activate delay start and close the door (top controls only).
To cancel delay start:
1 Press the [÷] or [-] button until "h:00" is indicated on the digital display.
2 Press and hold [Start] for 3 seconds to cancel the cycle. You may now start a new cycle.
InfoLight ® (model dependent - top controls only)
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the
LED is not visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
3 Release both buttons.
4 Press the "A" button until the display shows "::1.:01".
5 Press the "C" button to switch between "1:01" = ON and "1:00" = OFF and press [Start] to save.
Cycle Completion Signal (model dependent - top controls only)
1 Open the door and press the [On/Off] button.
2 Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
3 Release both buttons.
4 Press the "A" button until the display shows "b:02".
5 Press the "C" button to increase or decrease the tone "b:00" = OFF and "b:03" = LOUDEST
6 Press [Start] to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying results. The running time may increase slightly.
To turn intensive drying on:
1 Open the door (top controls only) and press the [On/Off] button.
2 Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
3 Release both buttons.
4 Press the "A" button until the display shows "d:00".
5 Press the "C" button to turn intensive drying on or off. "d:0:l." = ON and "d:00" = OFF
6 Press [Start] to save setting and close the door (top controls only).
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the factory setting (P:01):
1 Open the door (top controls only) and press the [On/Off] button.
2 Hold down the "A" button and press [Start] until the display indicates "H:00".
3 Release both buttons.
4 Press the "A" button until the display indicates "P:0::I.'.
5 Press the "C" button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically
P:0::I. = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
6 Press [Start] to save the setting and close the door (top controls only).
10
Loading ...
Loading ...
Loading ...