Loading ...
Loading ...
Loading ...
PROCEDURE A
_1 If you are using the new sleeve supplied with
your unit, skip to step 3. Otherwise, install the
plastic grille from the kit. Cut the plastic grille to
25-1/2" wide and 15-1/4" high. Place the
plastic grille to the inside of the wall sleeve at
the rear flange.
FIG. 4
_"_ Fasten the 4 washer screws to secure the grille
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressing into the square holes
of the rear flanges.
or
FIG. 5
_J Remove the backing from the Vertical
Insulation strip 158/18 x 13/8 X 13/8and attach that
to the inside right of the sleeve as shown
below. Remove the backing from the Around
Insulation strip 671/8 x 13/8X 25/32 and attach that
to the inside front of the sleeve as shown
below.
grille will minimize the recirculation of hot
discharge air.
Plastic rear grille
Steel rear c
FIG. 7
_4J Install the new unit into the wall sleeve.
r_To assemble trim, snap the tab of each piece
into the slot of the other piece as shown below.
Slide trim over the front of the air conditioner
until trim is flush with sleeve as shown below.
Trim (2 ea)
Wall
"I
/
FIG. 8
FIG. 6
D If you wish to keep the unit be operated at higher
performance state, remove the steel rear grille
and attach the plastic rear grille. The plastic rear
•Air conditioners covered in this manual pose
an excessive weight hazard. Two or more
people are needed to move and install the unit.
To prevent injury or strain, use proper lifting
and carrying techniques when moving unit.
•When handling the air conditioner, be careful
to avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-7-
Loading ...
Loading ...
Loading ...