Loading ...
Loading ...
Loading ...
Slowlyroutewatersupplylinethroughholein cabinet.
(Ifusingcoppertubing,itwill bendandkinkeasily,sobe
gentle.)Itshouldbefarenoughintothecabinetopening
to connectittothedishwasherinletonthefrontleft
sideofthedishwasher.
Slowlyturnwatershutoffvalveto "ON"position.Flush
waterintoashallowpanuntilcleartogetridofparticles
thatcouldclogtheinletvalve.Turnshutoffvalveto
"OFF"position.
iiii_if_i{_i{_i{_i_iiiiii_iii_iii_iiiiii_i_iiiiiii_i_ii_iii_i_i_ii_i_iiiiiii_iiiiiii_iiiiii_iiiiiiiB_);_;ii_);_;ii_ii_i_ii_i_ii_i_ii_i_ii_i_);i_;i_;;ii;i_;ii_);i_;i;i_ii_i_ii_i_ii_i_ii_i_ii_i;_i;i_;;ii;i_;;i;iiIi_;i_;;i_);_;ii_);_ii¸i_;i_;i_i;;ii;i_;ii_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_ii_i_i{_ii)y
InsfallDrain Hose
IMPORTANT: Always use a new drain hose. Check local
codes to determine if an air gap is required.
If needed, drill a 1 1/2" (3.8 cm) diameter hole in cabinet
wall or side of the opening closest to the sink.
Route drain hose as shown through hole in cabinet to the
front center of opening where drain connection will be
made. Tape drain hose to the floor in area shown. This will
prohibit it from moving when dishwasher is moved into
cabinet opening.
IMPORTANT: The drain hose connection of the disposer or
a waste tee must be made before the drain trap and at
least 20" (50.8 cm) above the floor where the dishwasher
will be installed.
Helpful Tip: To reduce vibration of the hose, keep the hose
away from the floor.
Option A, Waste disposer - no air gap
i iii
Drai
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle nose pliers to remove
plug.
3. Attach drain hose to disposer inlet
with large silver drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
Loading ...
Loading ...
Loading ...