Loading ...
Loading ...
Loading ...
Special InstallationInstructionsforAustralia and New Zealand.
Installingthe WaterLbe (continued)
Turn the Water On
Turn tile water On at the shutott _dve.
Tighten any connection that leaks.
Replace the access cover and tighten all screws
(on some models).
Plug in the Refrigerator
Plug ill tile refl-igerator to tile Power Outlet and
turn On.
IMPORTANT'. Always operate tile Refrigerator fl'om
a power sotlrce of tile same Voltage, Frequency
and Rating as indicated on the Re_l"igerator
Identification Plate. Operate tile Refl'igerator
fi'om an Earthed (Grounded) 3 Pin Power Outlet
fully accessible when tile retligerator is located
in its normal operating position.
Arrange tile coil of tubing so that it does not
vibrate against the back of the reti'igerator or
against the wall.
Push the refl'igerator back to tile wall, making sure
tile power cord and tile water line tubing are not
trapped, entangled or squashed by tile refl'igerator
(including tile wheels) or wall.
Start the Icemaker
Set tile icemaker power switch to tile ] position.
Tile icemaker will not begin to operate until it
reaches its operating temperature of-9°C or below.
It will then begin operation automatically if the
icemaker power switch is in the / position.
NOTE: In lower water pressure conditions, the
water valve may turn on tip to 3 times to make sure
enough water reaches the icemaker.
switch_
24
Loading ...
Loading ...
Loading ...