Loading ...
Loading ...
Loading ...
Operation
5,
Reviewthe unit's assemblyto confirm you haveperformed
all of the following: 6.
I. Make sure handle is in place and secure.
/
2. Check that oil hasbeen added to proper levelin /
engine crankcase.
t
3. Add proper fuel to fuel tank.
4. Check for properly attached hoseconnections.
7.
5. Check to make sure there are no kinks, cuts, or
damageto highpressure hose.
6. Provide a proper water supply (not to exceed 100°F) 8.
at an adequate flow.
7. Be sure to read "Safety Rules" and "How To Use
PressureWasher" before usingpressure washer.
Checklist Before Starting Engine
HOW TO USE PRESSURE
WASHER
If you haveanyproblems operating your pressurewasher,
pleasecattthe pressure washer helpllne at 1-877-224-0458.
How to Start Engine
The best way to start your pressure washer for the first
time isto follow these instructions step-by-step. This
starting informationalso appliesifyou havelet the it sit idte
for at least a day.
I. Placepressure washer near an outside water source
capableof supplying water at a flow rate greater than
5.0gallons per minute and no lessthan 20 PSIat
pressure washer end of garden hose.
2. Make sure unit isin a levelposition.
3. Check that high pressure hose is connected to spray
gun and pump. See"Preparing PressureWasher for
Use" for illustrations.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
Squeezetrigger on gun until you havea steady stream
of water. This purges pump of air and impurities.
Attach nozzle extension to spray gun (Figure 5).
Tighten by hand.
Choose spraytip you want to useand insertit into
nozzle extension. See "How to Use SprayTips".
Apply safety latch to spray gun trigger (Figure 6).
Safety Latch
9. Start engine according to instructions given in engine
owner's manual.
NOTE: If the recoil starter is hard to pull, squeeze the
spray gun trigger to relieve internal pump pressure.
• Squeezetrigger on spraygun each time recoil starter is
pulledand engine failsto start.
How to Stop Pressure Washer
• Turn engineoff according to instructionsgiven in engine
owner's manual.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A smallamount ofwater will squirt out when you
releasethe pressure.
Loading ...
Loading ...
Loading ...