Loading ...
Loading ...
Loading ...
Warning
messages
via the display
If several warning messages are
displayed simultaneously, deal with
each message individually.
While a warning message is
displayed, buttons cannot be
pressed.
Door aJarm
Cause
An appliance door has not been
closed properly or has been
open too tong.
Remedial action
Cl Ctosethe door.
The display goes out.
Sensor fault
Cause
A technical defect is possible.
Remedial action
_3 Conduct an appliance self test.
Low voltage
The display light has gone out.
Cause
The mains voltage has dropped
below the permitted limit value.
Remedial action
Buttons cannot be pressed. When
the mains voltage reaches the
stipulated value again, the warning
message goes out. If the warning
message is prolonged, inform your
power supply company.
Appliance
self-test
Before you call customer service,
conduct an appliance self test.
Switch off the appliance and
wait 5minutes. Keep the door
closed.
Cl Switch on the appliance.
_5 sec.
Cl Simultaneously hold down the
SETUP and ALARM OFF
buttons for 5 seconds.
The self test starts. Different
messages are display in succession.
If a fault is detected during the
self test, the ALARM symbol and a
corresponding error message,
e.g. for a sensor fault, are displayed.
Inform customer service about the
error message.
If the appliance self test does not
establish any faults, the required
temperature is displayed on
completion of the self test.
Resetting
factory settings
Recommended after a change of
owner.
_3 sec.
Simultaneously hold down the
SETUP and ALARM OFF
buttons for 3 seconds.
If the factory settings are reset:
an appliance which is switched
off switches on,
the Super function switches off
settings changed in Setup mode
are reset to factory settings.
16
Loading ...
Loading ...
Loading ...