Loading ...
Loading ...
Loading ...
TO REMOVE BELT GUARD (See Fig. 25)
• Remove L.H. outer and inner side shields (See "TO
REMOVE WHEEL" in this section ofthis manaul).
• Remove hairpinclipand clevispin from leftwheel. Pull
wheel out from tiller about I inch (2.5cm).
• Remove two(2) cap nuts and washers from sideofbelt
guard.
• Remove hex nut andwasher from bottomofbelt guard
(located behindwheel).
• Pull belt guard out and away from unit.
• Replace belt guard by reversing above procedure.
_ELT_UARD
CAPNUT
AND WASHER'':-
CAP NUT
AND WASHER
d' HEX NUT
AND
WASHER
(LOCATED
BEHIND
_. TIRE)
_ HAIRPIN CUP AND
CLEVIS PIN
FIG. 25
TO REPLACE GROUND DRIVE BELT (See
Figs. 25 and 26)
• Remove beltguard(See'TO REMOVE BELT GUARD"
in this section ofthis manual).
• Loosen belt guides"A"and"B" and also nuts=C"and
"D".
• Remove old belt byslippingfrom engine pulley first.
• Place new belt in groove of transmission pulley and
intoengine pulley. BELT MUST BE IN GROOVE ON
TOP OF IDLER PULLEY. NOTE POSITION OF BELT
TO GUIDES.
• Tighten belt guides "A"and "B" and nuts "C" and "D".
• Check belt adjustment as described below.
• Replace belt guard.
• Reposition wheeland replace clevis pin and hairpin
clip.
• Replace inner and outer side shields.
GROUND DRIVE BELT ADJUSTMENT (See
Fig. 26)
For proper belt tension,the extension spring should have
about 5/8 inch stretch when drive control bar is in "EN-
GAGED" position. Thistensionca. be a_ained as follows:
• Loosen cable clip screw securing the drive control
cable.
• Slide cable forward for less tension and rearward for
more tension until about 5/8 inch (16 mm) stretch is
obtained while the clutch control bar is engaged.
• Tighten cable clip screw securely.
ENGINE
NUT "C" PULLEY
BELT
GUIDE
BELT
GUIDE "B"
CABLE CLIP
SCREW
DRIVE
CONTROL
CABLE
LESS
TENSION
IDLER
PULLEY
TRANSMISSION
PULLEY
EXTENSION
SPRING
FIG. 26
16
Loading ...
Loading ...
Loading ...