Loading ...
Loading ...
Loading ...
Installation Instructions
REVERSING THE DOOR SWING (CONT.)
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remove it by grasping it
about 6" from each end and pulling its bottom edge
to_ard you.
Using a Torx ®drivm; move tile bottom hinge bracket
and plastic w-asher from tile right side to the left side.
NOTE: lithe washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the door.
Hinge8racke
For models with a base grille, beibre replacing the
base grille, remove the grille cap by removing the
screw. Screw the cap to the opposite side.
Replace the base grille by inserting the tops of tile
metal clips into the owal vents, making sure one of the
plastic tabs on tile back of the grille goes into each of
tile oven vents. Then push tile bottom of tile grille
forward until it snaps into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center hinge bracket by removing tile
three Torx ®screws.
NOTE: Keep these screws with tile hinge bracket.
They are long screws and will be used when installing
the hinge on tile other side.
On .some models, you will need to remove tile color-
matched caps from tile screw heads befbre you can
remove tile screv_. Use tile edge of a thin flat blade to
gently pry tile caps offthe screw heads. (A putty knife
works well for this.) Cover tile blade with rape to
prevent scratching tile paint.
Remove the three Torx ®screws from the center left
side of the cabinet. Screw them into the holes on
the right side.
Place the center hinge bracket over the holes at
the center left side of tile cabinet. Insert and
tighten the three long screws.
Replace the caps by snapping them over the screws
with your finger.
___ wCap
[] TRANSFER DOOR STOPS
On each door, move tile metal door stop from tile
right to the left.
Move any screws from the left to the right.
DoorStc
LeftSide RightSide
2O
Loading ...
Loading ...
Loading ...