Loading ...
Loading ...
Loading ...
11
2
N.B. When the range is not being used, set the gas knobs to their positions
and also close the gas shut-off valve placed on the main gas supply line.
CAUTION!
The range becomes very hot during operation. Keep children well out of reach.
LIGHTING GAS BURNERS FITTED WITH FLAME FAILURE
SAFETY DEVICE (Dual burner)
In order to light the burner, you must:
1. Push and turn the dial in an counter-clockwise direction up to the position
(maximum rate of inner + outer crown); push in and hold the dial until the ame has
been lit (g. 2.4).
The sparks produced by the lighter situated inside the relative burner will light the
ame.
In the event that the local gas supply conditions makes it difcult to light the burner
in position , try again with the dial in position .
2. Wait for about ten seconds after the gas burner has been lit before letting go the dial
(safety device activation delay).
3. Adjust the gas valve to the desired position.
If there is no mains electrical supply, the burners can be used with no restriction.
In that case, in order to light the burner, you must:
1. Bring a lighted match close to the burner (as per side gure) and keep it in place until
the burner has been ignited.
2. Push and turn the dial in an counter-clockwise direction up to the position
(maximum rate of inner + outer crown); push in and hold the dial until the ame has
been lit (g. 2.4).
In the event that the local gas supply conditions makes it difcult to light the burner
in position , try again with the dial in position .
3. Wait for about ten seconds after the gas burner has been lit before letting go the dial
(safety device activation delay).
4. Adjust the gas valve to the desired position.
If the burner ame should go out for some reason, the safety valve will automatically stop
the gas ow.
To re-light the burner, return the dial to the closed
position, wait for at least 1 minute
and then repeat the lighting procedure.
If your local gas supply makes it difcult to light the burner with the dial set to maximum,
set the dial to minimum and repeat the operation.
Loading ...
Loading ...
Loading ...