Loading ...
Loading ...
Loading ...
Heatingwith
inner(small)
elementonly
To Operate Dual Radiant Surface Elements (if equipped)
Symbols on the backguard are used to indicate which coil ofthe Dual Radiant
element will heat. The • symbol indicates the inner coil only. The (_) symbol
indicates both inner and outer coils will heat. You may switch from either coil
setting atany time during cooking. Push in and turn the control knob in either
direction to the desired setting as instructed above.
SINGLE AND DUAL RADIANT SURFACE ELEMENTS
Heating with Setting
both elements
HIGH (HI - g)
MEDIUM HIGH (7 - 8)
MEDIUM (5- 6)
MEDIUM LOW (2 - 4)
LOW (LO - 1) Keep warm, melt, simmer
Type of Cooking
Start most foods, bring water to a boil, pan broiling
Continue a rapid boil, fry, deep fat fry
Maintain a slow boil, thicken sauces and gravies, steam
vegetables
Keep foods cooking, poach, stew
................................................................. Note: The size and type of utensil used, and the amount and type of food
DualRadiantheatingareas being cooked will influence the setting needed for best cooking results.
onceramicsmoothtop (showninblack)
Setting the Warming Zone Control (some models)
h_
me_
0@0 Warn $
Warming Zone Recommended Food
Settings Chart
Food Item Heating
Level
Breads/Pastries LO
Casseroles LO
Dinner Plates with Food LO
Eggs LO
Gravies LO
Meats MED
Sauces MED
Soups (cream) MED
Stews MED
Vegetables MED
Fried Foods HI
Hot Beverages HI
Soups (liquid) HI
The purpose of the Warming Zone is to keep hot cooked foods at serving
temperature. Always start with hot food. It is not recommended to heat cold food
on the Warming Zone.
Atl food placed on the Warming Zone should be covered with a lid or aluminum foil
to maintain quality. For best results, when warming pastries or breads, the cover
should have an opening to allow moisture to escape. Do not use plastic wrap to
cover food. Plastic may melt onto the surface and be very difficult to clean.
Useonlydishware, utensils and cookwarerecommended for oven andcooktop use
on the Warming Zone.
Unlike the surface elements, the Warming Zone will not glow red
when it is hot.
Always use potholders or oven mitts when removing food from the
warm zone as cookware and plates will be hot.
Setting the Warming Zone Control
1. To set the controt, push ineither direction and turn the knob. The temperatures
are approximate, and are designated by HI, MED and LO. However, the control
can be set at any position between HI and LO for different levels of heating.
2. When done, turn the control to OFF. The Warming Zone will remain warm until
the hot surface indicator light goes off.
Tem perature Selection - Refer to the chart at the side column for recommended
heating levels. If a particular food is not listed, start with the medium level, and
adjust as needed. Most foods can be kept at serving temperatures by using the
medium level.
9
Loading ...
Loading ...
Loading ...