Loading ...
Loading ...
Loading ...
CLEANING AND MAINTENANCE - 107914779938/A
e
Cleaning the water circuit
• During this process, the overflowing of water
inside the oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
End of hydraulic circuit cleaning
10.At the end of the cleaning process, the
display indicates the request to drain water.
11.Clean and dry any residual water inside the
oven cavity.
Reservoir draining
12.Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
13.Touch the START button to start
draining the water into the jug.
The water starts to flow into the deep pan from
the drain pipe on the right side of the rear wall
of the oven cavity.
fig. 5
14.Wait for the end of the drain flow.
When finished, the reservoir indicator light
(in the information area on the right) and
the display indicate the end of the residual
water draining process.
15.Touch the CONFIRM button .
16.Drain the water from the deep pan.
17.Remove condensation from the base and
walls of the oven cavity, the door glass and
drip tray and the front of the appliance using
a sponge.
18.Close the door.
Sanitization
Sanitization with steam allows to remove the last
residues of descaling from the hydraulic circuit.
1. set a 40% combined steam function lasting
at least half an hour.
2. Open the door
3. Pull the loading drawer out of its housing.
4. Insert the funnel provided in the loading
drawer.
5. Pour 500 ml water (using a bottle or a
measuring jug).
6. At the end, remove the funnel and place the
loading drawer back in its place.
7. Close the door.
8. Touch the START button to start the
vapor selected function.
9. Wait for the function to be executed until the
end.
10. At the end of the function, drain the reservoir
as described above.
11.Wait for the end of the drain flow.
12.Drain the water from the deep pan.
13.Wipe off any spillage of water in the
cooking compartment with a cloth or
sponge.
14.Close the door.
Extraordinary maintenance
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
It is recommended to carry out the
cleaning process of the reservoir and
the hydraulic circuit a couple of times.
A cleaning solution can also be used
instead of water. In this case it is
advisable to carry out at least a couple
of water rinses afterwards, following the
instructions in this chapter.
Take care: wait for the oven cavity to
cool down.
Loading ...
Loading ...
Loading ...