Loading ...
Loading ...
Loading ...
7
1886
3 of 3
Short Housing
Screw
BAG
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Control
Installing the Switch Housing and Cap
ON
T
urn P
o
w
er
Lift the cap and align cap
holes with the extend tabs
of the fan housing.
Insert the cap screws found in
the hardware bag
4 of 4
Cap Screw
BAG
Installing the Blades
Repeat x3
x9
BAG
Blade Screw
x9
BAG
Blade Washer
Put the blade washers found in the hardware
bag onto the blade screws found in the
hardware bag. Then install the blade screws to
secure each blade to the fan.
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Partially install two switch housing screws, found
in the hardware bag, through the gasket
halfway into the motor housing as shown. It does
not matter which two screw holes you choose.
Using the three short housing
screws found in the hardware
bag, mount the lower switch
housing to the upper switch housing.
2 of 3 1 of 3
Switch Housing
Screw
Switch Housing
Screw
BAG BAG
Feed the wire plug through the center hole of the uppers
switch housing. Align the keyhole slots in the upper
switch housing with the two screws you just installed.
Lift the upper switch housing so that the keyhole slots
engage the two screws, and twist counterclockwise to
lock the upper switch housning into place.
Lift the the lower switch housing and
connect the plugs. Make sure to line up the
colored markings on the connectors and
that the connectors latch.
Insert the third screw found in the
hardware bag, into place and then tighten all
three screws.
Fan style may vary.
Note:
Loading ...
Loading ...
Loading ...