Loading ...
Loading ...
Loading ...
Mostlaunderingproblemsareeasily andwasherproblems.Ifyouneed
solvedifyouunderstandthecause, furtherassistance,seepage37.
Checktheselistsforcommonlaundry
Problem Possible Cause Solution
Washer Leaks Household ptumbing is leaking. Repair plumbing.
Inlet hoses not tight. Tighten hoses (see "INSTALLATION,"
Sections D & E).
Inlet hose washers not Reseat washers
properly seated. (see "INSTALLATION:' Section D).
Drain hose not properly Clamp drain hose
clamped or is off. (see "INSTALLATION:' Section C).
Drain is clogged. Remove drain clogs. Sink, standpipe,
or floor drain must be able to handle
17 galtons of water per minute.
Tub moved forward during Ensure tub is centered before
unloading, causing water to starting washer.
deflect off of tub ring.
Unit not level causing water Ensure front feet are installed and
to deflect off of tub ring. nuts are tightened. Level washer.
Reset rear legs
(see "INSTALLATION:' Section G).
Load is unbalanced. Spray Redistribute the load.
rinses are deflecting off of toad.
Washer is overloaded. Fills or Reduce load size.
spray rinses are deflecting off
of load.
Won't Drain/ Drain hose is kinked or Straighten or unplug hose
Won't Spin/ clogged. (see "INSTALLATION:' Section C).
Wet Loads
Correct operation of After a wash or rinse, the washer will
neutral drain, drain without spinning. After draining,
the spinning begins.
Lid is open. Close the lid.
Drain hose is more than Lower drain hose
96 inches above floor. (see "INSTALLATION:' Section C).
Too much detergent - Use tess detergent.
excessive sudsing.
Wrong cycle for load Choose a cycle with a higher spin
being washed, speed (see "OPERATION").
32
Loading ...
Loading ...
Loading ...