Frigidaire FAX054P7A16 room air conditioner

User Manual - Page 7

For FAX054P7A16.

PDF File Manual, 10 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Air Conditioner Features
(continued)
TO OPERATE ON FAN ONLY: YOU WILL SEE:
DO THIS:
PRESS MODE
BUTTON
CHQOSE FAN
ON_
LIGHT On
Note: Use this function only when cooling is not desired, such
as for room air circulation or to exhaust stale air. (Remember
to open the vent during this function, but keep it closed during
cooling for maximum cooling efficiency.) You can choose any
fan speed you prefer.
During this function, the display will show the actual room tem-
perature, not the set temperature as in the cooling mode.
TO USE THE ENERGY SAVER
FEATURE: YOU WILL SEE:
DO THIS:
PRESS MODE
BUTTON
CHOOSE
ENERGY SAVER
LIGHT On
Note: In this mode, the fan will continue to run for 3 minutes
after the compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the room temperature is
above the set temperature, at which time the compressor turns
back on and cooling stars.
TIMER: DELAY STOP / START
FEATURE
FIRST
DO THIS;
PRESS
THEN
DO THIS;
PRESS
YOU WiLL SEE HOW MUCH TiME IS CHOSEN:
LIGHT On
For Delay Stop, the unit must be in the On position.
For Delay Start, the unit must be in the Off position.
ust timer setting, tap or hold the UP arrow( _IL ) or the DOWN
arrow( _IV ) to change delay timer at .5 hour increments, up to 10
hours, then at 1 hour increments up to 24 hours. The control will count
down the time remaining until start (8, 7.5, 7, etc.). The Delay Start
mode automatically selects cooling with maximum Fan Speed. The
temperature maintained will be the same as previously set. To change
the set temperature, press 'COOL" then Up or Down arrows until the
desired temperature is indicated on the display. After 5 seconds, the
control will automatically change the display back to the hours re-
maining until the unit will start/stop. Turning the unit 'ON" or 'OFF" at
any time will cancel the Delay Start/Stop function.
The Delay Start/Stop Feature will work until the unit either starts or
stops. Once that happens the above steps have to be repeated again.
Loading ...
Loading ...
Loading ...