Loading ...
Loading ...
Loading ...
TROUBLESHOOTINGCHART
PROBLEM CAUSE CORRECTION
Poor cut - uneven
Excessive
vibration
Starter rope hard
topull
Graes catcher
not filling (ifso
equipped)
Hard to push
1. Wom, bent or loose blade.
2. Wheel heights uneven.
3. Buildup of grass, leaves
and hash under mower.
1. Worn, bent or loose blade.
2. Bent engine crankshaft.
1. Engine flywheel brake is on
when control bar is released
2. Bent engine crankshaft.
3. Blade adapter broken.
4. Blade dragging in grass.
1. Cutting height too low.
2. Lift on blade worn off.
3. Catcher not venting air.
1. Grass is too high orwheel
height is too low.
2. Rear of lawn mower
housing or blade dragging
in grass.
3. Grass cetcher too full.
4. Handle height position not
right for you.
1. Replace blade. Tighten
blade boll
2. Set all wheels at same
height
3. Clean underside of
mower housing.
1. Replace blade.T'_hten
blade belt.
2. Contactan authorized
servicecenter.
1. Depress control bar to
upper handle before
pulling starter rope.
2. Contact an authorized
service center.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface
to start engine.
1. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
1. Raise cuttingheight.
2. Raise rear of lawn mower
housing one (1) setting
higher.
3. Empty grass cetcher.
4. Adjust handle height to
suit.
15
Loading ...
Loading ...
Loading ...