Loading ...
Loading ...
Loading ...
10
• The safety locking arm may not be correctly engaged in the vertical
operating position. Check the top cover is properly aligned and the locking
arm is located rmly into the two grooves on either side of the juicer cover.
• Motor overload protection may have operated (see below).
excessive loads
• The juicer is equipped with an internal self-resetting overload to prevent the
motor from damage under heavy or continuous loads. If the motor suddenly
stops working, turn the dial to OFF, and unplug the unit from the power
outlet. Allow the juicer to cool for at least 30 minutes before operating again.
NOTE: The unit MUST be turned o in order for it to cool and be reset.
• Despite this overload protector, we suggest juicing in smaller batches,
without excessive pushing force, to avoid overheating and stalling and to
maintain the life of the motor.
up in the stainless
• Stop juicing, disassemble to scoop excess pulp o the juicer cover.
Reassemble and continue juicing. Alternating soft and hard ingredients
may help avoid this.
and reduced
extracted juice
• The cleaner the lter, the better the juice yield, and dryer the pulp. Be sure
to thoroughly clean the juicer as soon as possible after each use. Remove
the stainless steel lter basket and thoroughly clean mesh walls with a
cleaning brush. Rinse the lter basket under hot water. If the ne mesh
holes are blocked, soak the basket in a solution of hot water with 10%
lemon juice to unblock the holes or wash in the dishwasher (top shelf).
This will remove excess ber build up which could be inhibiting the ow.
the rim of the juicer
and the juicer cover
• Try a slower juicing speed (if possible) and push the food pusher down the
feed chute more slowly.
Juice sprays out
from spout
• The juice is being extracted too High; try a slower juicing speed (if possible)
and push the food pusher down the feed chute more slowly.
Loading ...
Loading ...
Loading ...