Loading ...
Loading ...
Loading ...
Umbau- und Montageanweisung
M.-Nr. 09469886 36 von 83
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten. 26.02.2021
NOTE
Damage to washer and carpeting.
A Drain all water out of the washer.
A Remove the dispensing assembly.
A Install the washer's shipping struts before tilting the washer on its side.
A The washer must be laid on a flat, soft underlayer (e.g., a carpet).
A Install the shipping struts; see the operating instructions.
A Lay the washer on its side.
A Unscrew and remove the washer feet.
A Install the spacer sleeves (1) on the set screws; see Fig. 11.
A Stick the stand and the washer together.
A Tighten the bolts inside the stand with an open wrench. Tighten the bolts alternately to ensure even tightening.
A Stand the washer/stand assembly upright.
A Install the sealing strips as shown on the inside of the rear panel; see Fig. 6.
A Use 3 CEM 4x10 raised-head screws to install the rear panel on the stand; see Fig. 12.
A Level the machine and stand using a spirit level.
A Twist in the connection pieces on the stand.
A Counter the stand feet.
A Secure the stand to the floor with the floor fastening kit, mat. no. 06593051.
NOTE
A Remove the shipping struts.
Drawer installation
A Place the drawer on the rails inside the stand and close it.
The drawer will audibly lock into place.
A To ensure that the drawer is correctly positioned on the rails, open it again and slam it shut.
Front panel adjustment
The machine front and the front panel of the drawer must be in line with each other. After installation, it may be
necessary to adjust the drawer front panel to align it. The height and tilt angle of the drawer front panel can be adjusted.
A Open the drawer.
A Adjust the height of the front panel:
- Remove the cover (A); see Fig. 13.
- To adjust the height, turn the adjustment wheel in the direction of the arrows as appropriate (B).
- When the height has been adjusted appropriately, reinstall the cover.
A Adjust the tilt angle of the front panel:
- To adjust the angle, twist the drawer rods as appropriate; see Fig. 14.
A Close the drawer.
When installing machines next to each other: Connect the stands
A Place the stands next to each other.
A Loosen the counter nuts on all stand feet.
Loading ...
Loading ...
Loading ...