Loading ...
Loading ...
Loading ...
A. GENERAL INSTALLATION INSTRUCTIONS
1. These appliances can be used as a free standing or built-in unit. See the minimum clearances for built-in usage.
2. Place your refrigerator on a flat solid floor that is strong enough to support the unit when it is fully loaded. To level your refrigerator,
adjust the levelling screw-in feet at the bottom of the unit.
3. When moving or relocating your refrigerator do not incline the unit on more than a 45 degree angle.
4. Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight and heat sources
will increase electrical consumption and lower the life expectancy of your unit. Extreme cold ambient temperatures may also cause
the unit to misperform.
5. Avoid locating the unit in damp areas.
6. Plug the unit into an exclusive, properly installed and grounded wall outlet. Do not under any circumstances cut or remove the third
(ground) prong from the power cord. Any questions concerning power and/or electrical grounding should be directed to a certified
electrician or authorized products service center.
PART III! INSTALLATION INSTRUCTIONS
INSTALLATION
B. INSTALLING YOUR REFRIGERATOR
!
1. Move the appliance into its final position .
2. Level the appliance by adjusting the feet.
3. Compare the alignment of the appliance to the surrounding cupboard . The
top of the appliance should be level from side to side (see diagram below) .
4. If the appliance now rocks from one corner to the opposite rear corner, this
means that the floor is uneven. You may need to put some packing under the
fridge to the rear of the appliance . You could use thin pieces of solid material
such as thin board, vinyl floor tiles or laminate .
5. You may now need to fine tune the installation by repeating steps 2, 3 and 4 .
6. Wipe off any dust that has accumulated during shipping and clean by
following the directions in Part VIII ( Care & Maintenance)
7. Plug the appliance into the power point. Do not use a double adaptor or
extension cord .
8. It is recommended that you let the appliance sit for an additional hour or two
before you put anything in it . This will confirm that it is operating correctly and
also to make any adjustments far easier.
!
Congratulations! You have successfully installed your cellar/refrigerator/freezer
!
DOOR LOCK
This unit comes with an optional key lock. The keys are located inside the plastic bag that contains the user manual. To unlock the door,
insert the key into the lock and turn counterclockwise. To lock the door, simply reverse the operation making sure the metal pin is
engaged completely. Then remove the key and place it is a secure place for safekeeping.
COMPRESSOR REFRIGERATORS
www.kingsbottle.com! 6
Loading ...
Loading ...
Loading ...