Loading ...
Loading ...
Loading ...
em_: v n_!!_Ace _4 a_ed Li_
From Inside the Dryer Cabinet
I.int should be removed every 2 years, or more often, depending on
dryer usage. Cleaning shouldbe done by a qualified person.
From the Exhaust Vent
I.int should be removed every 2 years, or more often, depending on
dryer usage.
0
Install and store your dryer where it will not freeze. Because some
water may stay in the hoses, freezing can damage your dryer. If
storing or moving your dryer during freezing weathec winterize it.
Non-Use or Vacation Care
Operate your dryer only when you are at home. If you will be on
vacation or not using your dryer for an extended period of time, you
should:
1. Unplug dryer or disconnect power.
2. Gas models only: Close shutoff valve in gas supply line.
3. Clean lint screen. See "Cleaning the I.int Screen."
4. Turn off the water supply to the dryer. This helps to avoid
unintended flooding (due to a water pressure surge) while you
are away.
Moving care
For power supply cord-connected dryers:
1. Unplug the power supply cord.
2. Gas models only: Close shutoff valve in gas supply line.
3. Gas models only: Disconnect gas supply line pipe and remove
fittings attached to dryer pipe.
4. Gas models only: Cap the open fuel supply line.
5. Steam models only: Shut off water faucet.
6. Steam models only: Disconnect the water inlet hose from faucet,
then drain the hose. Transport hose separately.
7. Make sure leveling legs are secure in dryer base.
8. Use masking tape to secure dryer door.
For direct-wired dryers:
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Reinstalling the dryer
Follow the "Installation Instructions" to locate, level, and connect
the dryen
Water Inlet Hoses
Replace inlet hoses and hose screen after 5 years of use to reduce
the risk of hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, record the date of replacement.
To winterize dryer
1. Unplug dryer or disconnect powen
2. Gas models only: Close shutoff valve in gas supply line.
3. Shut off water faucet.
4. I)isconnect water inlet hose from faucet and drain.
To use dryer again
1. Flush water pipes. Reconnect water inlet hose to faucet. Turn on
water faucet.
2. Plug in dryer or reconnect power.
3. Gas models only: Open shutoff valve in gas supply line.
The dryer light automatically turns on inside the dryer drum when
you open the door.
To change the drum light
1. Unplug dryer or disconnect power.
2. Open the dryer door. I_ocate the light bulb cover on the back
wall of the dryer. Remove the screw located in the lower right
corner of the cover. Remove the cover.
3.
Turn bulb counterclockwise. Replace the bulb with a 10-watt
appliance bulb only. Replace the cover and secure with the
screw.
4. Plug in dryer or reconnect power.
1. Disconnect powen
2. Disconnect wiring.
3. Steam models only: Shut off water faucet.
4. Steam models only: I)isconnect the water inlet hose from faucet,
then drain the hose. Transport hose separately.
5. Make sure leveling legs are secure in dryer base.
6. Use masking tape to secure dryer door.
12
Loading ...
Loading ...
Loading ...