Loading ...
Loading ...
Loading ...
38 MAINTENANCE
Replacing the Water Filter
Replace the Water Filter :
Approximately every six months.
When the Replace Filter
icon turns on.
When the water dispenser output decreases.
Before Replacing the Water Filter:
If the top shelf, located below the water lter, is in the
highest position, it will need to be removed prior to
replacing the water lter.
To remove any shelf : Tilt up the front of the shelf (1)
and lift (2). Pull the shelf out.
1
Remove the old water lter.
Lower or remove the top left shelf to allow the
water lter to rotate all the way down.
Pinch the sides to open the water lter cover.
NOTE
Replacing the water lter causes a small amount of
water (around 1 oz. or 25 cc) to drain.
Wrap a cloth around the front end of the water lter
cover to collect any leaking water. Hold the water
lter upright, once it is removed, to prevent any
remaining water from spilling out of the water lter.
2
Make sure to rotate the lter down completely
before pulling it out of the lter head.
Pull the water lter downward and turn to
counterclockwise.
3
Replace with a new water lter.
Take the new water lter out of its packing and
remove the protective cover from the o-rings.
With the water lter tabs in the horizontal position,
push the new water lter into the lter head and
turn to clockwise.
4
Rotate the water lter up into position and close
the cover. The cover will click when closed
correctly.
5
After the water lter is replaced, dispense 2.5
gallons of water (ush for approximately 5
minutes) to remove trapped air and contaminants
from the system.
NOTE
Do not dispense the entire 2.5 gallon amount
continuously. Press and release the dispenser pad
for cycles of 30 seconds ON and 60 seconds OFF.
Loading ...
Loading ...
Loading ...