Loading ...
Loading ...
Loading ...
TROUBLESHOOTING - DRYER cont.
First try the solutions suggested here or visit our website to possibly avoid the cost of a service call.
In U.S.A. www.maytag.com/help - In Canada www.maytag.ca.
if you experience
Possible Causes
Solution
No heat Household fuse is blown or circuit The drum may be turning, but you may not have heat. Electric
breaker has tripped, dryers use 2 household fuses or circuit breakers. Replace both
fuses or reset the circuit breaker. If the problem continues, call
an electrician.
Supply line valve not open. For gas dryers, the valve is not open on the supply line.
Incorrect power supply. Electric dryers require 240-volt power supply.
Check with a qualified electrician.
Cycle time too short Automatic cycle ending early. The load may not be contacting the sensor strips. Level the dryer.
Lint screen clogged.
Dryer fabric softener not properly used.
Use Timed Dry for very small loads. Change the Dry Level
setting on Sensor Dry cycles.
increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint on load Lint screen should be cleaned before each load.
Stains on load or drum
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Loads are wrinkled Load not removed from dryer at the Select Wrinkle Prevent feature to tumble the load without heat to
end of the cycle, avoid wrinkling.
Dryer tightly packed. Dry smaller loads that can tumble freely to reduce the chance of
wrinkles forming.
Odors You have recently been painting, Ventilate the area. When the odors or fumes are gone from the
staining, or varnishing in the area area, rewash and dry the clothing.
where your dryer is located.
The electric dryer is being used for the The new electric heating element may have an odor. The odor will
first time. be gone after the first cycle.
Load is too hot Laundry items were removed from the Allow Cool Down cycle to finish before removing laundry from
dryer before the end of the cycle, dryer. All cycles are cooled slowly to reduced wrinkling and
make it easier to handle. Items removed before Cool Down
may feel very warm.
A high temperature cycle was used. Select a lower temperature, and use a sensor drying cycle. These
cycles sense the temperature or the moisture level in the load and
shut off when the load reaches the selected dryness. This reduces
overdrying.
21
Loading ...
Loading ...
Loading ...