Loading ...
Loading ...
Loading ...
ToConnectWaterSupplyLineToIce
Maker Inlet Valve
1. Disconnect refrigerator from electric power
source.
2.
3.
Place end of water supply line into sink or
bucket. Turn ON water supply and flush
supply line until water is clear. Turn OFF
water supply at shutoff valve.
Remove plastic cap from water valve inlet
and discard cap.
4. If you use copper tubing - Slide brass
compression nut, then ferrule (sleeve)
onto water supply line. Push water supply
line into water valve inlet as far as it
will go (1/4 inch / 6.4 mm). Slide ferrule
(sleeve) into valve inlet and finger tighten
compression nut onto valve. Tighten
another half turn with a wrench; DO NOT
over tighten. See Figure 1.
If you use stainless steel tubing - The
nut and ferrule are already assembled on
the tubing. Slide compression nut onto
valve inlet and finger tighten compression
nut onto valve. Tighten another half turn
with a wrench; DO NOT over tighten. See
Figure 2.
5. With steel clamp and screw, secure water
supply line (copper tubing only) to rear
panel of refrigerator as shown.
6. Coil excess water supply line (copper
tubing only), about 21/2turns, behind
refrigerator as shown and arrange coils so
they do not vibrate or wear against any
other surface.
7. Turn ON water supply at shutoff valve and
tighten any connections that leak.
8. Reconnect refrigerator to electrical power
source.
9. To turn ice maker on, lower wire signal
arm (side mounted) or set the ice maker's
On/Off power switch to the 'T' position
(rear mounted).
Plastic Water
Steel
Clamp
r_ Brass
ICompression
Nut
L_ Ferrule
I (Sleeve)
I__-- Copper
L,.,:_ter line
Water Valve
Bracket
X-Valve Inlet
- Water Valve
_erwater line
from household
water supply
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Figure 1
Plastic water Tubi
Clamp
Steel
water Line
Bracket
Water Valve
_ft. Stainless Steel Waterline
fromhousehold water supp!y
Figure 2
These instructions do not cover after market
ice maker installation. Instructions in after
market ice maker kit should be used.
Loading ...
Loading ...
Loading ...