Loading ...
iNSTALLATiONiNSTRUCTiONS
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
[] Measuring tape [] Drill
[] Pencil [] 7/64" drill bit
[] Phillips screwdriver
Parts Supplied (not shown to scale
Rails (2)
Bottom duct Trimkit frame
tJ
Short screws (14)
(11+ 3 extra)
Long wood screws (6 - painted)
(4 + 2 extra)
LOCC] O_'_: ,,_ _, ............
The microwave oven may be installed over a built-in oven. if
installing over a built-in oven, make sure there is a minimum of 3"
(7.6 cm) between the top of the lower oven cutout and the
microwave oven cutout floor.
The microwave oven may also be installed in a cabinet by itself
(without a built-in oven below). For best usability, we recommend
a minimum distance of 36" (91.4 cm) from the floor to the cutout
floor.
Make sure the surrounding cabinetry has clearance to open and
close freely. Allow a clearance of at least 1%_" (4.0 cm) below the
cutout floor (3" [7.6 cm] for installation above a built-in oven), and
a clearance of at least 2" (5.1 cm) above the cutout opening.
2 II
(5.1cm)
19/16"
II A
O O ...........i....................
T
36"
(91.4 c
JL 2"
cm)
3 II
"(7.6 cm)
A. Upper cabinet D. Lower cabinets
B. Microwave oven cutout E.Floor
C. Lower oven cutout
I
For minimum depth requirements, see chart.
t
17" (43.2em)
min.
17Va"(43.6era)
max.
11/'16"
(2.7 cm)
A
3 II
(7.6 cm)
D C
11/'16"
(2.7 cm)
B
A. Trim kit frame overhang
B. Cutout for lower oven
C. Recommended region for receptacle
location (no less than 6" [15.2 cm] to
the right of cutout centerline)
D. Cutout centerline
Receptacle Location Minimum Depth
Within recommended 18" (45.7 cm) with flush receptacle;
region 21" (53.2 cm) with non-flush receptacle
Outsiderecommended 19V2"(49.5 cm) with flush receptacle;
region 22V2" (57.2 cm) with non-flush
receptacle
NOTES:
[] Depth requirements depend upon receptacle and its location
within or outside of recommended region. See illustration and
chart above.
[] Height dimension is critical: 17" (43.2 cm) minimum, 17Vs"
(43.5 cm) maximum.
[] Width measurement has +1/16" (2 mm) tolerance.
[] 3" (7.6 cm) minimum dimension is from lower oven cutout
ceiling to microwave oven cutout floor.
[] Trim kit frame extends l_Ae" (2.7 cm) above and below the
cutout opening.
2
Loading ...
Loading ...
Loading ...