Loading ...
Loading ...
Loading ...
Installation
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Leveling Freezer Drawer Tolevelthecabinetusingt.e frontro,ers:
(if necessary) 1 Slightly open freezer drawer. Liftthe toe
grille and gently pull forward (see illustration).
1 Check gasket seal around top, bottom, 2 You can raise or lower each door. Use
and sides of freezer drawer, a 3/8inch socket wrench to turn the
2 If gasket is not sealed, open drawer and adjustment screws (1 per side).
slightly loosen four drawer screws (two ......
on each side) to allow drawer to rotate.
3 Close drawer and recheck the seal
on the gasket (A). Open the drawer
grabbing by the sides in the center (B).
Be careful not to rotate the drawer.
Remove hex RemoVe hex
head drawer ys ... head drawer
screw _ J _ _--\._ screw
-i- _f _,-_.
/d'T'_.,P'R_qDo Not Remove I_P_
__11 |Remo've
_"a_d DrsHwex
Screw Screw
4
5 Recheck gasket seal.
Tighten four drawer screws.
Against
Freezer
Drawer
_Toe Grille Must_
/ ._I' \ Fit in Slot On / t,_,
I p"_ _} Anti-tiP Bracket L _!-I
\ f_'._',_ I_ ScrewRVasher _1;,,_¢_
Assembly
_L___ (3) Retaining Clips
3
4
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw
counterclockwise.
Ensure both doors are bind-free with
their seals touching the cabinet on all
four sides and that cabinet is stable.
After unit is leveled, lower anti-tip leg
until it contacts the floor.
° ' Door
iiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
t iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
i11111111111111111111111111111111111111111111111111111111
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiH!!!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
o
Door'
=
Grab
D rawer
at Center
Ili from Both
Sides
Then
=lli Drawer
Out
Level Refrigerator & Adjust
Doors (if necessary)
Guidelines for final positioning of your
refrigerator:
All four corners of the cabinet must rest
firmly on the floor.
The sides should tilt _Ainch (6 mm) from
front to back (to, ensure that doors close 5 Install the toe grille by fitting into place.
and seal propeny/.
Doors should align with each other and
be level.
Most of these conditions can be met by
raising or lowering the adjustable front rollers.
Loading ...
Loading ...
Loading ...