Crosley WCC05F 5.3 cu. ft. Capacity Chest Freezer

Owners Manual - Page 3

For WCC05F.

PDF File Manual, 27 pages, Read Online | Download pdf file

WCC05F photo
Loading ...
Loading ...
° Replace or repair all electric service cords that have become damaged or frayed.
° Never unplug your freezer by pulling onthe power cord° Always grip plug firmlyand pull straight out
from the outlet
Be careful not to roll over or damage the cord, when moving the freezer°
Unplug you rfreezer before making repairs or cleaning, itis our recommendation that servicing be
done by a qualified technician.
Unplug your freezer or turn power off at the circuit breaker or fuse box tnorder to avoid touching a live
wire, when replacing a burned-out light bulb. Turning the control to OFF turns off the compressor,
but does not disconnect power to other electrical components.
Do not pinch, knot, or bend power cord in any manner.
if your electricity goes off follow thte procedure:
Call your power company to see how long the power will be out,
If service is to be interruptedfor less than 24 hours, keep freezer closed. This witl hetp food stay
frozen.
If service is to be interrupted for more than 24 hours, either remove food and store in frozen food
locker or another freezer.
InstallingYourFreezer
Your dealer is responsible for unpacking your freezer properly. Should any evidence
of mishandling be present, contact him immediately.
Installation Requirements:
A 115 Volt, 60 Hz, AC 15 or20 ampere fused and properly
grounded electrical supply(for personal safety) is required.
Refer to the serial plate for the correct electrical rating.
A separate circuit used only by this appliance is recommended.
DO NOT USE AN EXTENSION CORD.
DO NOT CUT, REMOVE OR BYPASS THE GROUNDING
PRONG FROM THE PLUG.
To preventthe freezer from being turned off accidentally,
do not plugunit intoan outlet controlled bya wall switch or pull cord.
3-Prong
r°iT u
andGroundedOutlet
Ifvoltage varies by t0 % or more, the performance of the freezer may be affected. Operating the
freezer with insufficientpowercan damage the motor. The warranty does not cover this damage. If
you suspect your household voltage is high or low, consult your powercompany for testingo
Picking a Location:
Locate thefreezer so that extension cords are not necessary and thefreezer is away from any
flammables such as gasoline,
Make sure that the flooryou choose to place your freezer on will support the weight of the freezer
when it is full.
Due to the lid and hinge arrangement, it is impossible to install the freezer directly against the wall.
The spacing on the back is essential for maintaining proper air circulation around the freezer. It is
recommended thatyou leave a 3inch (75 mm) space on all sidesof the freezer.
Locate the freezer where itwill be convenient to use and away from direct suntight or heat
sources such as the range, dishwasher, laundry equipment or furnace. Freezers are designed to
operate efficiently between 4°C to 32°C (40°F to 90°F). Temperatures above or below this range
will cause the freezer to operate less efficiently. Additional compressor heaters are not
recommended.
If the place selected for your freezer is damp or moist, as in some basements, place freezer on
wooden blocks_ (Two or three boards under entire length will assure adequate support.)
The freezer shouldnever be placed on acarpeted floor.
In order for your freezer to work properly, it must be level with the floor. If not, you mayadd metal or
wood shims between feet pads and floor.
Note: the floor must be strong enough to support a fully loaded freezer,
Ifthere istape residue on the freezer, remove with amixture of warm water and mild detergent or
touch the residue with the sticky side of tape already removed.
DO NOT REMOVE THE SERIAL PLATE.
-3-
Loading ...
Loading ...
Loading ...