Loading ...
Loading ...
Loading ...
FirstSteps
AIR SPACE
I u
Installation
Unpacking and Leveling - Upright Freezers
_1_'_ To allowdoor to
cloee and seal proper_, DO NOT let
food packages extend peetthe front
of shelves.
ShelfFront
Before starting the freezer, follow these important first steps:
Installation
• Choose a place that isnear a grounded electrical outlet.
• The freezer should be located where surrounding temperatures wilt not exceed
110°F (43°C). Temperatures of 32°F (0°C) and below wilt NOT affect freezer
operation. Additional compressor heaters are not recommended.
• AIIowspacearoundtheunitforgoodaircirculation. Leavea3inch(75mm)space
on all sides ofthe freezer for adequate circulation.
Leveling
The freezer must have allbottom corners resting firmly on asolid floor. The floor must
be strong enough tosupport afully loaded freezer. NOTE: ItisVERYIMPORTANTfor
yourfreezerto be level inorderto function properly. Ifthefreezer is not leveled during
installatioin, the door may be misaligned and not close or seal properly, causing
cooling, frost, or moisture problems.
To Level Upright Unit:
After discarding crating screws and wood base, use a carpenter's level to level the
freezer from front-to-back. Adjust the plastic leveling feet infront, 1/2bubble higher,
so that the door closes easily when left halfway open.
To Level Chest Unit:
If needed, add metal or wood shims between feet pads and floor.
Cleaning
• Wash any removable parts, the freezer interior, and exterior with mild detergent
and warm water. Wipe dry. DO NOT USE HARSH CLEANERS ON THESE
SUFFACES.
• Do notuse razor blades orother sharp instruments, which can scratch the appliance
surface when removing adhesive labels. Any glue left from the tape can be
removed with a mixture of warm water and mild detergent, or touch the residue
with the sticky side of tape already removed. DO NOT REMOVE THE SERIAL
PLATE.
DOOR REMOVAL (UPRIGHT MODELS)
If door must be removed, (UNPLUG THE UN1T_
1. Gently lay freezer on its back, on a rug or blanket.
2. Remove two base screws and base panel. Remove
wire from clips on bottom of cabinet. (Figure 1)
3. Unplug connector, if required, by holding the cabinet
connector in place, and pulling door
connector out. (Figure 1)
4. Remove bottom hinge screws.(Figure 1)
5. Remove plastic top hinge cover.
6. Remove screws from top hinge.
7. Remove top hinge from cabinet.
8. Remove door and bottom hinge from
cabinet.
9. To replace door, reverse the above
order and securely tighten all screws to
prevent hinge slippage.
LID REMOVAL (CHEST MODELS)
See Instructions on Hinge label.
(UNPLUG THE UNIT.)
Base
Pan_ase PanelScrews
i
o
\
Bottom
Figure I
4
Loading ...
Loading ...
Loading ...