Loading ...
Loading ...
Loading ...
19
!6LEAK TESTING
GAS
ON
GAS
ON
●
Make sure all oven and burner knobs are set to OFF before connecting range to gas supply.
●
After final gas connection is made, turn gas supply on and test all connections in gas supply piping for gas leaks with a soapy water solution.
●
In order to avoid property damage or serious personal injury, never use a Iighted match or open flame.
If a leak is present, tighten joint or unscrew, apply more joint compound, tighten again and retest connection for leak.
!7COOKTOP BURNERS
Lifting off
Yellow tip
Good flame
Cooktop burners
●
To check that the ignition system operates correctly, light each burner by itself,
then all burners in combination.
●
Check for a well-defined blue flame without any yellow tipping.
●
If any abnormality is evident, check that the components of the burner assembly
are located properly.
●
When installing the burner port ring, align the two locating pins in the bottom side
of the port ring with the locating notch and center holes on the top side of the
simmer ring, and make sure these are properly engaged. Important! Incorrect installation
may produce a potentially dangerous flame and result in poor burner performance.
●
No air shutter adjustment is possible on the cooktop burners.
Proper operation is achieved with factory installed settings for the correct gas type.
●
If proper operation cannot be obtained, contact Customer Care or your nearest
Fisher & Paykel Authorized Service Center.
●
The range and cooktop must not be used by the customer until proper operation
has been achieved.
Loading ...
Loading ...
Loading ...