Loading ...
Loading ...
Loading ...
8
1886
Assembling the Light
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light ControlGlass
Installing the Glass
ON
Turn Power
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Partially install two light kit
screws, found in the hardware
bag, through the gasket halfway
into the motor housing as shown.
It does not matter which two
screw holes you choose.
Using the three Short Light Kit
Screws, found in the hardware
bag, mount the lower switch
housing to the upper switch housing.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
Raise the LED assembly to the upper
switch housing . Align the screw holes in
the LED assembly with the screw holes in
the upper switch housing.
3 of 3
Short Light Kit
Screw
BAG
Align the keyhole slots in the top of
the upper switch housing with the
partially installed light kit screws.
Wrap the keyhole slots around the
screws and twist counterclockwise
Install the third screw.
Tighten all three
screws securely.
Connect the plugs from the upper
switch housing and the LED
assembly. Make sure to line up the
colored markings on the connectors.
Loading ...
Loading ...
Loading ...