Loading ...
Loading ...
Loading ...
PURESOURCE TM ICE AND WATER FILTER (SOME
MODELS)
Order new filter cartridges through the dealer
where you bought the refrigerator, contact the
Electrolux Solutions Hotline at 1=800-944-9044, or
go to our web site at www.frigidaire.com, it might
be good to order some filter cartridges when you
first install your refrigerator. Be sure to ask for the
RG-100 PureSource TMreplacement cartridge.
System Startup:
Water supply does not need to be turned off, however, do not
use ice and water dispenser while installing filter. The filter
cartridge has already been installed in the filter housing at the
factory. Refer to the How to Prime the Water Supply System
section to properly fill the system with water.
The PureSource TM * NGRG-2000 Ice and
Water Filter System with the RG-IO0 cartridge
is tested and certified by NSF International, the
nationally recognized and respected, not for
profit, certification organization for public health
safety. The PureSource TM*system is tested
and certified to ANSl/NSF Standard 42. See performance
data sheet for specifications. This system should not be
used on water that is microbiologically unsafe or with water
of unknown quality unless the water has been adequately
disinfected before or after traveling through the filtration
system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
• Rated Capacity - 400 gallons
• Rated service flow - .5 GPM
• Maximum/Minimum Rated Pressure - 100/30 PSI
• Maximum/Minimum Operating Temp. - 100°/33 ° F
Changing the Filter:
Water conditions vary throughout the world, but changing the
water filter every 6 - 9 months normally will ensure the highest
possible water quality. Ice jams in the ice maker and/or hollow
ice cubes (partially frozen cubes with water inside), may
also be a sign that your water filter needs changing. The
Filter Status light will turn red after 400 gallons of water has
flowed through the ice and water dispenser. Also, if the filter
has been in a refrigerator that has not been in use for awhile
(during moving for example), change the filter before reinstalling
the refrigerator. The dispenser system will also operate without
filtration (with filter cartridge removed).
To change filter:
It is not necessary to turn the water supply off to change the filter.
1. Open freezer door and leave open until filter change is
complete.
2. Turn OFF side mounted ice maker by raising wire signal
arm to the UP position. Turn OFF rear mounted ice maker
by pressing ON/OFF power switch to the "O" position.
3. Hold filter cup firmly, and unscrew towards left. Some
water could leak out as you remove cup. This is normal.
Filter cartridge should come down with cup. If cartridge
remains in housing, pull down gently, while twisting filter
back and forth.
4. Rinse out cup under running water.
5. The large o-ring that seals the filter system fits in the o-ring
groove inside the cup. Should the o-ring fall out during filter
cartridge replacement, simply place it back in the groove
prior to screwing the cup back in place. If the o-ring
becomes damaged, you will need to order one from
the Electrolux Solutions Hotline.
6. Discard old filter cartridge.
7. Remove new filter cartridge from packaging. Place in cup.
The end with the small o-ring should be up, out of the cup.
8. Screw cup, with filter, back onto housing. Do Not Use
Wrench To Reinstall Cup. Filter cartridge will self-align as
cup is tightened. Be sure cup is completely tightened with
PureSource TM logo facing outward. Do Not Tighten Past
Stop.
9. Turn ON side mounted ice maker by lowering wire signal
arm to the DOWN position. Turn ON rear mounted ice
maker by pressing ON/OFF power switch to the "r'
position.
10. Check for leaks. Open refrigerator door. Wipe any water
leaks from the filter cup. Fill a glass with water. If there is a
leak, unscrew filter cup, and reinsert the filter
cartridge. Check placement of large O-ring. Reinstall filter
cup, making certain it is tightened completely.
11. To prime filter system and purge air from water line,
continue flushing the system for approximately 3 minutes
to assure that the purest water possible is stored in the
water tank. There will be noticeable spurts and sputters
as the system pushes air out through the system and
out the dispenser nozzle.This is normal.
Loading ...
Loading ...
Loading ...