Loading ...
Loading ...
Loading ...
Assembly
Making Radial Arm Parallel to Frame
The radial arm must be parallel to the
frame so that when lowered onto the
table, the blade will be the same dis-
tance from the table at all points.
1.Lock miter lock.
2. Unlock rip lock. Pull blade carriage
to mid-way position along radial arm.
Lock rip lock.
3. Lift front end of radial arm and slide
front table between radial arm and
frame, towards rear. Note: To make ade-
quate clearance, you might have to raise
radial arm by turning elevation handle.
4. Continue to support front end of
radial arm while using elevation handle
to lower radial arm until it just rests on
edge of front table. Note: You will have
to remove table without changing radial
arm elevation.
!
5. Leave front table in place. Wrench
tighten, until just snug, front bolt on
each side where side frame attaches to
base.
6. Without changing elevation of radial
arm, remove front table.
19
Loading ...
Loading ...
Loading ...