Loading ...
Loading ...
Loading ...
Wall Sleeve Brands:
Top View
Rear Louvers
7
60
60
#7 Whirlpool ( 23 Deep)
1. Redirect the louvers at the back of the wall
sleeve as shown in the illustration. The use
of pliers is recommended.
1. Place (2) 1 x1 x14 seals against each side.
2. Gently slide unit in and check if amount extend-
ing from the sleeve is sufficient once the trim
frame is attached.
3. If position is Ok, remove unit and proceed to
the next step. If not go to step 8.
4. Attach (1)1 x1 x25 long seal in the center
at the top of the sleeve. Remove the backing
paper and press into position.
5. Attach (2) 1 x1 x14 seals to the left and
right sides of the sleeve.
6. Cut the 1 x1 x25 long seal to 14 long
and attach it vertically to the rear grill 7 from
the left side.
7. Attach the tapered spacer blocks to the floor of
the sleeve. Now go to step 13.
8. Attach 1 x x14 long seal over the solid
vertical portion of the rear grille.
9. Attach (2) 4 x3 x1 foam blocks with the
slot overlapping the seal above.
10. Install the divider into the slots of the foam
blocks. You may need to trim the length to size.
11. Cut the 1 x1 x25 seal to fit the top of the
sleeve. The pieces must be fitted flush to the
edge of the divider.
12. Attach (2) 1 x1 x14 seals along the side
of the sleeve again making sure all seal are
flush.
13. Center unit and gently slide unit into sleeve.
14. Before sliding all-the-way back, remove 2nd
screw from front on left side of unit.
15. Remove the plastic washer from the screw.
16. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
17.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
18.Seal & Frame the unit as described on the last
page of these instructions.
Use these next steps if the unit requires extra
extension into the room.
1
/
2
1
/
2
1
/
2
1
/
2
Because of the increased unit depth, first try
dry fitting using the method described below:
1
/
2
1
/
2
1
/
2
1
/
2
1
/
2
3
/
4
1
/
2
1
/
2
1
/
2
1
/
2
1
/
2
1
/
2
1
/
2
18
Loading ...
Loading ...
Loading ...