Loading ...
Loading ...
Loading ...
4
INSTALLATION INSTRUCTIONS
Unpacking
Remove Packaging Materials
■ Remove tape and glue residue from surfaces before turning
on the freezer. Rub a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and
dry.
■ Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your freezer. For more
information, see “Freezer Safety.”
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your freezer before using it. See the cleaning instructions in
“Freezer Care.”
Location Requirements
1. Your freezer operates most efficiently when located in an area
where the temperature is normally between 32°F (0°C) and
110°F (43°C).
2. Keep flammable materials and vapors, such as gasoline,
away from freezer. Do not install the freezer near an oven,
radiator or other heat source.
3. Check the strength of the floor before installing your freezer. It
should hold the weight of a freezer fully loaded with food.
4. Level the freezer from side to side and front to back so that
the lid will seal properly. Use shims to level the freezer if
necessary.
5. Allow at least 3" (7.5 cm) of air space on both sides of the
freezer and 2" (5 cm) between the back of the freezer and the
wall. Leave room above the freezer to open the lid.
6. It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need adjustment,
contact a designated service company.
NOTE: Do not cover the freezer with items such as blankets,
sheets, tablecloths, etc. This reduces air circulation.
Electrical Requirements
Recommended grounding method
A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your freezer be provided. Use an outlet that
cannot be turned off by a switch or pull chain. Do not use an
extension cord.
WARNING
Excessive Weight Hazard
Use two or more people to move and install freezer.
Failure to do so can result in back or other injury.
When Moving Your Freezer:
Your freezer is heavy. When moving the freezer for
cleaning or service, be sure to protect the floor. Always pull
the freezer straight out when moving it. Do not wiggle or
“walk” the freezer when trying to move it, as floor damage
could occur.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from freezer.
Failure to do so can result in death, explosion, or fire.
➧
2" (5 cm)
3" (7.5 cm)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Loading ...
Loading ...
Loading ...