Loading ...
Loading ...
Loading ...
iill_ _ ÷* *sill
To Operate Dual Radiant Surface Elements (If equipped)
Symbols on the backguard are used to indicate which coil of the Dual Radiant
element will heat. The • symbol indicates the inner coil only. The (_) symbol
indicates both inner and outer coils will heat. You may switch from either coil
setting at any time during cooking. Push in and turn the control knob in either
direction to the desired setting as instructed above.
000 _i@_ 000 Ri_£t
Heatingwith Heatingwith
inner(small) bothelements
elementonly
SINGLE AND DUAL RADIANT SURFACE ELEMENTS
Setting Type of Cooking
HIGH (HI - 9) Start most foods, bring water to a boil, pan broiling
MEDIUM HIGH (7 - 8) Continue a rapid boil, fry, deep fat fry
MEDIUM (5 - 6) Maintain a slow boil, thicken sauces and gravies, steam
vegetables
MEDIUM LOW (2 - 4) Keep foods cooking, poach, stew
LOW (LO - 1) Keep warm, melt, simmer
Note: The size and type of utensil used, and the amount and type of food
DualRadiantheatingareas being cooked will influence the setting needed for best cooking results.
on ceramic smooth top (shown in black)
Setting the Warming Zone Control (if equipped)
OFF
hi
reed
0@0 warmiHI
0 @ z,=,
Warming Zone Recommended Food
Settings Chart
Food Item
Breads/Pastries
Casseroles
Dinner Plates with Food
Eggs
Gravies
Meats
Sauces
Soups (cream)
Stews
Vegetables
Fried Foods
Hot Beverages
Soups (liquid)
Heating
Level
LO
LO
LO
LO
LO
MED
MED
MED
MED
MED
HI
HI
HI
The purpose of the Warming Zone is to keep hot cooked foods at serving
temperature. Always start with hot food. It is not recommended to heat cold food
on the Warming Zone.
All food placed on the Warming Zone should be covered with a lid or aluminum foil
to maintain quality. For best results, when warming pastries or breads, the cover
should have an opening to allow moisture to escape. Do not use plastic wrap to
cover food. Plastic may melt onto the surface and be very difficult to clean.
Use only dishware, utensils and cookware recommended for oven and cooktop use
on the Warming Zone.
Unlike the surface elements, the Warming Zone will not glow red
when it is hot.
Always use potholders or oven mitts when removing food from the
warm zone as cookware and plates will be hot.
Setting the Warming Zone Control
1 To set the control, push in either direction and turnthe knob. The temperatures
are approximate, and are designated by HI, MED and LO. However, the control
can be set at any position between HI and LO for different levels of heating.
2. When done, turn the control to OFF. The Warming Zone will remain warm until
the hot surface indicator light goes off.
Temperature Selection - Refer to the chart at the side column for recommended
heating levels. If a particular food is not listed, start with the medium level, and
adjust as needed. Most foods can be kept at serving temperatures by using the
medium level.
Loading ...
Loading ...
Loading ...