Loading ...
Loading ...
Loading ...
7
PROGRAMMING YOUR
COFFEEMAKER
SETTING THE CLOCK
When the coffeemaker is plugged in,
12:00 will flash.
TURN THE FUNCTION KNOB TO CLOCK
Press Hour and Minute buttons to select
the desired time. Hold buttons down to scroll
through the digits, or press and release to
advance one digit at a time. When scrolling,
the numbers will advance slowly and then
speed up. When the number displayed
approaches the desired time, press and release
to advance one digit at a time. Be sure the PM
indicator is on if a PM time is desired. To finish
setting the clock, turn the Function knob to any
other setting or simply wait until the numbers
stop blinking.
SETTING THE AUTO-ON TIME
When you turn the Function knob to Prog, the
previously selected Auto On time, or the default
time (12:00) will flash.
1. Turn the Function knob to Prog. Follow
directions under SETTING THE CLOCK,
(above) to program your start-brew time.
2. Turn the Function knob to Auto On.
The LCD will display the current time.
3. Press and release On/Off button to activate.
The white Auto On light will illuminate,
indicating that the coffeemaker is in Auto On
mode. The On/Off white indicator light will
illuminate when the brew cycle begins at the
time you have selected. Both lights will go off
when Keep Warm cycle ends.
NOTE: To start brew time at the same time
the next day, simply make sure the Function
knob is on Auto On and press and release
On/Off button once more. The white Auto On
light will go on..
CHARCOAL WATER FILTER
Your coffeemaker comes with a charcoal water
filter that eliminates chlorine, bad tastes and
odors from tap water.
Inserting the Water Filter
• Remove the filter from the polybag and soak
it, fully immersed, in cold tap water for
15 minutes.
• Lift the water filter holder out of the water
reservoir (see diagram, page 5).
• Press down on the filter compartment and
pull toward you to open.
• Place filter into the holder and snap it closed.
Be careful – improper placement can tear the
filter skin.
• Flush filter by running cold tap water through
holes in bottom of compartment for 10
seconds.
• Allow the filter to drain completely.
• Slide the water filter holder back into the
channel in the water reservoir, pushing it
down to the base of the unit.
NOTE: We recommend changing the water
filter every 60 days or after 60 uses, and
more often if you have hard water.
Replacement filters can be purchased
in stores, by calling Cuisinart
Consumer Service
(1-800-726-0190) or
at www.cuisinart.com.
Loading ...
Loading ...
Loading ...