Loading ...
Loading ...
Loading ...
4
Installation Instructions
ANTI-TIP BLOCK
NORMAL INSTALLATION STEPS
Anti -Tip BLOCK Installation Instructions
To reduce the risk of tipping of the drawer, the
Anti-Tip block must be properly installed located 14
13/16-inches above the floor on which the Drawer
Microwave will sit. The anti-tip block must be provided
and pre-installed by the purchaser of the product or
builder before install can be done. The anti-tip block
is not provided by installer. See Figures 1 and 2.
The Anti-Tip block
prevents serious
injury that might
result from spilled
hot liquids.
If the Drawer
Microwave is ever
moved to a different
location, the Anti-Tip
block must also be
moved and installed.
When installed to the wall, make sure that the screws
completely penetrate the dry wall and are secured in
wood or metal so that the block is totally stable. When
fastening, be sure that the screws do not penetrate
electrical wiring or plumbing.
ELECTRIC OUTLET
The electrical requirements are a 120 volt 60 Hz,
AC only, 15 amp. or more protected electrical
supply. It is recommended that a separate circuit
serving only this appliance be provided.
The drawer is equipped with a 3-prong grounding
plug. It must be plugged into a wall receptacle
that is properly installed and grounded. Should
you only have a 2-prong outlet, have a qualified
electrician install a correct wall receptacle.
Note: If you have any questions about the
grounding or electrical instructions, consult a
qualified electrician or service person.
* Can also be installed using an electrical outlet
in an adjacent cabinet within the area where the
provided electrical cord can reach. Always check
electrical codes for requirements.
T
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of
an electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for
the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the appliance is properly grounded.
Improper use of the
grounding plug can
result in a risk of
electric shock.
Do not use an
extension cord. If
the power supply
cord is too short,
have a qualified
electrician or
serviceman install
an outlet near the
appliance.
DRAWER INSTALLATION
1. Place the drawer adjacent to the wall or
cabinet opening. Plug the power supply cord into
the electrical outlet.
2. Carefully guide the drawer into the prepared
opening. Avoid pinching the cord between the
oven and the wall.
3. Slide the drawer all the way until the mounting
flange is flush with the face of the cabinet. See
Figure 5.
4. Open the drawer. Using the
4 holes on the drawer as a
template, pre drill the cabinet
using a 1/16” bit. See Figure 5.
5. Secure the drawer with the 4
screws supplied.
Mounting
Flange
Parts supplied
4 Screws
Permanent and Correct Installation
3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
Suggested
electrical outlet
location*
5”
4”
6”
3
1
/2”
Anti-Tip
block
Figure 3
Figure 4
Figure 5
WARNING
Loading ...
Loading ...
Loading ...