Loading ...
Loading ...
Loading ...
Problem Possible Causes Solutions
bake or self-clean The time of day is incorrect. Set clock with correct time of day before adding a delay start
did not start at the setting. See "Setting the clock" in Setting Oven Controls
time expected, section.
Strong odor from Self-clean was started for the
range or smells hot. first times or from a new
range.
Unable to remove Oven door locks immeadiately
items from oven after after setting self-clean.
starting self-clean.
Oven door did not Oven is too hot.
unlock after the self-
clean cycle.
It is normal for odors to occur during self-clean, especially
during the first self-clean cycle. It is recommend to ventilate the
kitchen area. Open any windows and if available turn on an
exhaust fan or overhead range hood during the self-clean cycle.
Press cancel to stop self-clean. Wait for the oven door to
unlock. Once unlocked, remove any items left in the oven, close
the oven door and set for self-clean again.
Allow about 1 hour after the self-clean cycle for the oven to cool
enough before the oven door will unlock.
Self-clean feature Incorrect control setting. Carefully follow the prepartion and programming instructions
will not start, under Self-cleaning.
Oven door open. The oven door must lock before the self-clean cycle will start.
Self-clean will not The control has determined
restart, oven is still too hot to restart
self-clean (some models).
Be sure the oven door is closed before starting self-clean.
In some cases after cancelling self-clean, you may be required
to wait up to 4 hours before the self-clean feature may be used
again. Watch display for any messages.
Soil not completely Heavy soils. Clean time too Set self-clean feature for maximum cleaning time. Remove any
removed after self- short or spillovers were left excessive spillovers from oven before starting self-clean.
cleaning cycle, inside oven. Carefully follow prepartion instructions under "Self-cleaning".
Failure to clean soil from the
oven frame, the door liner
outside the oven door gasket
and the small area at the front
center of the oven bottom.
These areas are not within the self-cleaning area, but get hot
enough to burn on residue. Clean these areas before starting a
self-clean cycle. Burned-on residue may be cleaned with a stiff
nylon brush and water or a nylon scrubber. Be careful not to
damage the oven gasket.
Interrupted by power outage. Once power is restored restart self-clean.
Powdered ash inside This is normal. The Wait for the oven to completely cool. Wipe away any residue
the oven cavity after temperature of the self-clean or powdered ash from the oven interior using a clean damp
self-clean cycle, feature turned dirt to ash. cloth or paper towel.
Oven rack finish is Oven racks left inside oven Remove all racks from oven before starting self-clean. Clean
dull or discoloring, during self-clean, after removing from the oven using a mild, abrasive cleaner
following manufacturer's instructions. Thoroughly rinse and dry.
Oven rack no longer Oven racks left inside oven Remove all racks from oven before starting self-clean. To ease
slides in or out of during self-clean, rack movement, remove from oven and clean if needed. Then
oven easily, apply a small amount of vegetable oil to a paper towel and wipe
oil on edges of oven racks. Do not use lubricant sprays.
38
Loading ...
Loading ...