Loading ...
Loading ...
Loading ...
Decorative trims (all models):
It is advisable to clean the decorative trims regularly
to prevent any build up of soiling which may detract
from the appearance of the cooker.
The recommended method of cleaning is to wipe
over the trims with a soft cloth wrung out in hot water
or mild non-abrasive cleaner. (If in doubt try the
cleaner on a small area of trim which is not
noticeable in normal use).
Then, after wiping with a cloth wrung out in clear
water, dry with a soft clean cloth.
Never use scouring pads or abrasive cleaners/
powders which may scratch the surface.
Take care during cleaning not to damage or distort
the door seals. Do not lift the door seal from the
oven chassis, if necessary remove the seal by
carefully unhooking the corner clips.
Take care that the rating label edges are not lifted
during cleaning, and furthermore that the lettering is
not blurred or removed.
Control Panel:
Wipe with a damp cloth and polish with a dry cloth.
Stainless trims:
Regularly wipe with a clean, damp cloth and polish
with a clean dry cloth.
Grill:
Remove the wire grid food support, it is best to
wash these items immediately after use to prevent
stains from being burnt on when used again. Wipe
out the Grill compartment, use a fine steel wool soap
pad to remove stubborn stains from the floor of the
compartment.
Main oven:
1.Glass Door - open the oven door fully. The glass
panel may now be cleaned. Stubborn stains can be
removed by using a fine steel wool soap pad. Do
not use scouring pads, or abrasive powder, which
will scratch the glass. Ensure that the glass panel is
not subjected to any sharp mechanical blows. For
Care and Cleaning
slight soiling the inner glass panel may be cleaned,
while still warm. For removing stubborn stains see
next page.
2. Remove the rod shelves. Use a fine steel wool
soap pad to remove stubborn stains from the rod
shelves and the floor of the oven. Refer to the
instructions on previous page for cleaning the 'Stay
clean' panels.
Replacement oven lamp:
WARNING: Ensure that the appliance is switched
off before replacing the lamp to avoid the
possibility of electric shock.
Open the oven door and remove the rod shelves.
Using a suitable cloth to protect the fingers grip the
light glass dome, unscrew anti-clockwise and lift.
Reach into the aperture and unscrew the lamp anti-
clockwise. Fit replacement lamp (25W 300°C rated
SES), refit dome.
Do not use the oven lamp as/for ambient lighting
ENEN
19
Wall-mounted splashpanel:
A wall-mounted splashpanel is available as an
optional extra from the Spare Parts Department. See
back cover for details.
Care must be taken that rating label edges are not
lifted during cleaning and furthermore that the
lettering is not blurred or removed.
For details of your nearest Service Centre please see
the separate service leaflet. If you have any queries
regarding service or spares, our Spares and Service
Division will be pleased to advise.
Loading ...
Loading ...
Loading ...