Loading ...
Loading ...
Loading ...
5
WARNING:
Prolonged wear of any watch can cause skin irritation for some people.
Clean the watch band regularly by wiping it with a damp towel. Be
careful not to get the watch wet, as this could damage the unit. Do not
use soaps or household cleaners, as they can get trapped under the
band and irritate the skin. Always dry the band before putting it back on.
Irritation can also occur if the band is too tight or too loose. If redness,
swelling, itchiness, or any other irritation occurs, remove the watch and
consult a physician.
GETTING STARTED
Master Power Switch
When you use KidiZoom
®
Smartwatch DX2 for the
rst time, you will need to slide the Master Power
Switch (located on the underside of the watch) to
the ON position
. You may need a small tool
such as a paper clip to move the switch to the on
position. Then, fully charge the watch before rst
use. A full charge will take about 3 hours.
When the Master Power Switch is set to the OFF position, the unit will
not function and the battery will not charge. Only move the switch to the
OFF position when the watch will not be used for an extended period
of time.
Note: It is not necessary to switch off the watch in daily use. Once the
master power switch is off, the watch will stop functioning and after it is
turned on again, the time and date has to be reset.
BATTERY RECHARGING
Note: Adult operation required.
To charge KidiZoom
®
Smartwatch DX2, the watch needs to be
connected to a computer with the included Micro-USB Cable. To do so
correctly, please follow these steps:
• Make sure that the Master Power Switch is set to the ON position
before charging.
• Pull up the rubber cover of the Micro-USB Port on the side of the
watch.
• Insert the Micro-USB Cable (small end) into the Micro-USB Port on
the watch.
Loading ...
Loading ...
Loading ...