Loading ...
Loading ...
Loading ...
Mulching Tips
Mulching finely cuts the grass so that the grass can be easily
recycled. Becausethe nutrients are returned to the soil, the
lawn will need less fertilizer. To correctly mulch the lawn,
follow the tips below.
oThe grass must be dry. if the grass is wet, it will be
difficult to cut and cause heavyclumps of grass.
oThe grass must not be too tall. The maximum height to
effectively cut is 4 1/2 inches. Set the height adjusters
so that only the top third of the grass is cut.
oif the grass is more than 4 1/2 inches high, two
mowings will be necessary. Forthe first mowing, set the
height adjusters in the highest position. Then, lower the
height adjusters for the second mowing.
oKeep a sharp edge on the blade. A blade that is not
sharp will causethe ends of the grass to become brown.
- Cleanthe underside of the mower housing. Grass and
other debris can keep the mower from working
correctly.
If the quality of cut is marginal, try the following:
oSet the height adjusters at a higher cutting height.
, Cut the grass more frequentty
, Operatethe mower at a slower ground speed.
oOverlapthe cutting swaths instead of cutting a full
swath with each pass.
oMow across the marginal areas a second time.
m
Preparingthe Engine
ENGINEDOESNOTCONTAINOiL OR GASOLINE
Using the bottle of oil supplied in the carton, fill the engine
with the proper amount of oil. Seethe engine manufacturer's
instructions for the type of gasoline and oil to use: Before
you usethe unit, readthe information on safety, operation,
maintenance,and storage.
WARNING:F@ow the engine manufacturer's
instructions for the type of gasoline and oil to
use.Always use a safety gasoline container. Do
not smoke when adding gasoline to the engine.
When inside an enclosure, do not fill with
gasoline. Beforeyou add gasoline, stop the
engine. Let the enginecool for several minutes.
iMPORTANT:This unit is equipped with an internal
combustion engine and must not be used on or nearany
unimproved forest-covered, brush-covered or grass-covered
and unless the engine's exhaust system is equipped with a
spark arrester meeting applicable local or state laws (if any).
if a spark attester is used, it must be maintained in effective
working order by the operator.
Rnthe Stateof Californiathe above is required by law
(Section 4442 of the California Public ResourcesCode).
Other states may have similar laws. Federallaws apply on
federal lands. Seean Authorized Service Centerfor a spark
arrester for the muffler.
Note: Actual sustained enginepower wil/ likely be lower due
to operating limitations and environmental factors.
Note: Theoperation of a new engine wil/ sometimes result in
a s/ight amount of smoke. This smoke is caused by paint or
oil on or around the muffler. This is normal and only
expected during initial operation.
FinalPreparation
Before you use the mower, check the assembly of the
wheels, the handle,and the controls. Makesure all the
fasteners are tight. Make sure the throttle control (if
equipped) and the engine stop lever work correctly.
If the mower is equipped with height adjusters, makesure
the height adjusters function properly. Before starting the
engine, makesure each height adjuster is set at the desired
height Bee"Adjusting The Height Of Cut" in the Maintenance
sections.
11
Loading ...
Loading ...
Loading ...