Loading ...
Loading ...
Loading ...
6
EXTRA RINSE
This option can be used to automatically add a second
rinse to most cycles.
DEEP CLEAN + STEAM
The Deep Clean + Steam option adds additional soak
and wash time to many cycles to help remove tough
stains, as well as a steam boost for added cleaning
power. Deep Clean + Steam uses a heater within the
washer to maintain the selected temperature setting
throughout the wash period. Deep Clean + Steam may
be selected as an option with other cycles.
NOTE: The Deep Clean + Steam option may increase
the selected temperature.
DEEP FILL
If you would like to add the maximum amount of water
to your wash cycle, select the Deep Fill option.
NOTES:
• Expect longer cycle times due to extended fill times
when using the Deep Fill option.
• Deep Fill is not available in the Normal cycle mode.
CYCLE STATUS LIGHTS
The Cycle Status Lights show the progress of a cycle.
At each stage of the process, you may notice sounds
or pauses that are different from traditional washers.
DELAY
When Delay Start has been selected, the Delay light will
illuminate and remain illuminated until the cycle begins.
LID LOCKED
To allow for proper load sensing and spinning, the lid
will lock and the Lid Locked light will turn on. This light
indicates that the lid is locked and cannot be opened.
If you need to open the lid, touch START/PAUSE. The
lid will unlock once the washer movement has stopped.
This may take several minutes if the load was spinning at
a high speed. Touch and hold the START/PAUSE button
again for up to 3 seconds to restart the cycle.
Avoid opening the lid during sensing. The sensing
process will start over when the washer is restarted.
7
SENSING
When the Start/Pause button is touched and held,
the washer will rst perform a self-test on the lid lock
mechanism. You will hear a click, the basket will make
a slight turn, and the lid will unlock briey before locking
again.
Once the lid has locked the second time, the washer
will use short, slow spins to estimate the load size.
These sensing spins may take 2 to 3 minutes before
water is added to the load and you may hear the hum of
these spins. If the sensing light is on, then the washer is
working properly. You will hear the motor turn the basket
in short pulses to thoroughly wet the load. The washer
will then move the load briey, pause to allow water to
soak into the load, and resume adding water.
This process may repeat until the correct amount of water
has been added for the load. You may also hear water
owing through the dispenser, adding detergent to the
load.
NOTE: Avoid opening the lid during sensing. The sensing
process will start over when the washer is restarted. The
sensing light may also come on during the Wash portion
of the cycle. This is normal.
WASH
You will hear the motor and agitator moving the load.
Unlike traditional washers, the load is not covered with
water. Rather than diluting detergent as done in an
agitator-style washer, this washer delivers the detergent
directly to the soils. The motor sounds may change at
different stages in the cycle. The wash time is determined
by the selected Soil Level.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load.
SPIN
The washer spins the load at increasing speeds for
proper water removal based on the selected cycle
and spin speed.
DONE
Once the cycle is complete, this light will come on.
Remove the load promptly for best results.
Loading ...
Loading ...
Loading ...