Loading ...
Loading ...
Loading ...
LINE REPLACEMENT
1. Remove spoot by firmly pulling on
tap button.
2. Clean entire surface of hub and
spool
3. Replace with a pre-wound spool, or
cut two lengths of 12-1/2 feet (3.8
meters) of 0.080" (2 mm) diameter
Craftsman _ brand line.
A(_-WARNING: Never use wire,
rope, string, etc., which can break off
and become a dangerous missi{e.
4. thserf ends of the Ithes about 1/2
inch (1 cm) into the small holes on
the inside of spool.
Spool
//
Line exit holes Une in Notch
\
\
\
Une in Notch
• Hub
CARBURETOR ADJUSTMENT
A(_-WARNING: Keep others away
when making idle speed adjustments,
The trimmer head will be spinning dur-
ing this procedure, Wear your protec-
tive equipment and observe all safety
precautions,
The carburetor has been carefully set
at the factory, Ad ustments may be
necessary if you not ce any of the fo -
lowing conditions:
• Engine will not idle when the throttle is
released.
Make adjustments with the unit sup-
ported so the cutting attachment is off
the ground and will not make contact
with any object, Hold the unit by hand
while running and making adjustments.
Keep all parts of your body away from
the cutting attachment and muffler,
Idle Speed Adjustment
Allow engine to idle, Adjust speed until
engine runs without stalling (idle
speed too slow).
• Turn idle speed screw clockwise to
increase engine speed if engine
stalls or dies.
• Turn idle speed screw counterclock-
wise to decrease engine speed.
Idle Speed Screw
5. Wind the line evenly and tightly
onto the spool. Wind in the direc-
tion of the arrows found on the
spool.
6. Push the lines into the notches,
leaving 3 to 5 inches (7 - 12 cm)
unwound.
7. Inserf the lines into the the exit
holes in the hub as shown in the
illustration.
8. Align the notches with the line exit
holes.
9. Push spool into hub until it snaps
into place,
10. Pull the lines extending outside of
the hub to release the lines from
the notches,
Air Filter Cover
If you require further assistance or are
unsure about performing this proce-
dure, contact your Sears Service
Centre,
10
Loading ...
Loading ...
Loading ...