Loading ...
Loading ...
Loading ...
Most laundering problems are easily solved if you understand the cause.
Check these lists for common laundry and washer problems. If you need
further assistance, see service and assistance information on the back cover.
Problem Possible Cause 8olution
Washer Leaks Household ptumbing is Ieaking. Repair plumbing.
Inlet hoses not tight. Tighten hoses (see "Installation
Instructions," Sections D & E).
Inlet hose washers not Reseat washers (see "Installation
properly seated. Instructions," Section D).
Drain hose not properIy CIamp drain hose (see "Installation
cIamped or is off. Instructions," Section C).
Drain is dogged. Remove drain clogs. Sink, standpipe,
or floor drain must be able to handle
17 gal (64 L) of water per minute.
Tub moved forward during Ensure tub is centered before
unloading, causing water to starting washer.
deflect off tub ring.
Unit not level causing water Ensure front feet are installed and
to deflect off tub ring. nuts are tightened. Level washer.
Reset rear legs (see "Installation
Instructions," Section G).
Load is unbalanced. Spray Redistribute the Ioad.
rinses are deflecting off load.
Washer is overloaded. Fills or Reduce Ioad size.
spray rinses are deflecting off
Ioad.
Won't Drain/ Drain hose is kinked or Straighten or unptug hose (see
Won't Spin/ dogged. "Installation Instructions," Section C).
Wet Loads
Correct operation of After a wash or rinse, the washer will
neutral drain, drain without spinning. After draining,
the spinning begins.
Lid is open. Close the Iid.
Drain hose is more than Lower drain hose (see "Installation
96 in (2.4 m) above floor. Instructions," Section A).
Too much detergent - Use less detergent.
excessive sudsing.
Wrong cycle for load Choose a cycle with a higher spin
being washed, speed (see "Operating Your
Washer").
34
Loading ...
Loading ...
Loading ...