Loading ...
Loading ...
Loading ...
5655
MAINTENANCE AND CLEANING
Cleaning and Maintenance
Your dishwasher should be protected from freezing if you plan to leave it for
extended periods in an unheated place. Have a qualified person do the following:
To disconnect service:
1. Turn off the electrical power to the dishwasher at the supply source by moving
fuses or tripping circuit breaker.
2. Turn off the water supply.
3. Place a pan under the inlet valve, then disconnect water line from the inlet valve
and drain it into a pan.
4. Disconnect drain line from pump and drain the water into a pan.
To restore service:
1. Reconnect the water, drain, and electrical power.
2. Turn on water and electrical power supply.
3. Fill the detergent cup and the rinse aid cup and run the dishwasher through a
heated-wash cycle.
4. Check all connections to make sure they do not leak.
TROUBLESHOOTING
Troubleshooting
Refer to this table to correct minor issues before calling for service.
ERROR CODES
If there is an air gap installed with your dishwasher, make sure it is clean so the
dishwasher will drain properly. Air gap is not part of your dishwasher. Before you
clean the air gap, turn off the dishwasher, then remove the plastic air gap cover and
clean with a toothpick.
Caution:
• If an overflow occurs, turn off the main water supply before calling for
service.
• If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
CODE MEANING POSSIBLE CAUSE
E1 Slow fill time/fill time has
exceeded time alloted
• Faucet is not opened
• Water intake is restricted
• Water pressure is too low
E4 Overflow A leak in the dishwasher
E8 The orientation of the distributary
valve not working.
The wire is not connected correctly,
or the distributary valve is broken.
E9 A button has been touched
for more than 30 seconds (by
anything, including water).
Anything (including water)
touching a button.
Loading ...
Loading ...
Loading ...