Loading ...
Setting the Clock
The C_ockpad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
time in the display will flash (See Figure 1).
Figure 1
INSTRUCTIONS
To set the clock (example below for 1:30)
1 Press c_ock:"CLO" will appear in the display (Figure 2).
2. Press 0 pads to set the time of day to 1:30 (Figure 3).
"CLO" will stay in the display. Press
and the clock will start (Figure 4).
"CLO" will disappear
Changing between 12 or 24 hour time of day display
1• Press and hold C_ock'for 7 seconds (Figure 3). After 7 seconds,
"12h" (Figure 5) or "24h" (Figure 6) will appear in the display and
the control will beep once.
2• Press c_ea,,to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6)•
_iiiiii!!!i_ii_iiiiii!iii;
Clear
3. Press to accept the change or press /off to reject the
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours•
PRESS
1 3 0
Clock for 7 seconds
( Clean
/ .................
Clear
or
/Off
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Loading ...
Loading ...
Loading ...