Loading ...
Loading ...
Loading ...
Wipewithsoft,moistcloth.
- Donotuseanyscouringcleaningagent.
- Removeresiduesofdetergentandcleaningagentimmediately,
- Absolutelynocleaningwithwaterjet.
1,
2.
3.
Set cycle selector to Off, unplug from power supply.
Open service door and remove.
Loosen screws and remove protective foil.
Remove emptying hose from the holder.Take off cap, let
sudsy water drain out. Replace cap.
2. Removing dispenser: Press the dispenser up from below with your finger.
Clean dispensing shell and dispenser with water and brush and dry off.
3. Set in dispenser and click in (stick the cylinder on the guide pin).
4. Push in detergent dispenser.
Leave detergent dispenser open, so that remaining water can dry.
4.
5.
Carefully unscrew pump cap (remaining water),
Clean interior, threads of the pump cap and pump housing (pump impeller
must be able to be turned).
6. Replace pump cap and screw on tightly, handle is
vertical. Replace emptying hose in the holder.
7. Screw on protective foil.
8. Replace service door and close.
Leave the loading door open so that the drum can dry.
Rust spots - use chlorine-free cleaner, no steel wool.
Not necessary if proper amount of detergent used. In case it is needed follow the descaling
agent manufacturer's instructions.
i Close the washing machine door properly; washing may be caught.
Open water tap completely, supply hose kinked / pinched;
Clean screen -> Page 9; Water pressure too low.
i Oversudsing -> Page 70;
i Clean pump -> Page 9; Drain pipe / drain hose clogged.
Motor malfunction. Call customer service!
Turn off machine, wait 5 seconds and turn on again. If the display shows again,
call customer service -> Page 13.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 liter of water into dispenser tI and start Drain cycle.
Release water pressure in the supply hose:
1. Close water tap!
2. Select desired cycle (except for Spin/Drain).
3. Select Start/Pause. Let cycle run approx. 40 seconds.
4. Set cycle selector to Off. Unplug from main power supply!
Cleaning screen:
1. Remove hose from water faucet.
- Rinse the strainers under flowing water.
- Remove hoses on the rear,
take out screen with pliers and clean.
2. Replace hose and check for leaks.
Loading ...
Loading ...
Loading ...