Loading ...
Loading ...
Loading ...
36 - INSTALLATION 914779520/B
not remove this plate for any reason.
• Make sure that the plug and socket are of
the same type.
• Avoid using adapters, gang sockets or
shunts as these could cause overheating
and a risk of burns.
• Leave the appliance standing for at least
two hours before turning it on for the first
time.
• If it is necessary to replace the power cable,
this must be performed by an authorised
technician from Technical Support Service.
Positioning
Choice of location
Always install the appliance in a dry place with
satisfactory ventilation. Depending on its climate
class (stated on the nameplate inside), the wine
cellar can be used in different temperature
conditions.
SN = Subnormal - N = Normal
ST = Subtropical - T = Tropical
• Locate the appliance at least 3 cm away
from electrical or gas cookers and at least
30 cm away from combustion heaters or
radiators.
• The appliance must not be installed near
heat sources. If this is not possible, suitable
insulation must be used.
• Ensure that the appliance is located with
sufficient space for the door to open and for
the internal drawers and shelves to be
removed, if necessary.
• To ensure correct cooling of the condenser,
respect the clearance requirements when
mounting.
Levelling
To level the appliance correctly, there are two
feet on the lower front.
Fixing to the furniture
To fix the appliance to the furniture:
1. open the door;
2. tighten the 4 screws provided.
3. cover the screws with the supplied bushings.
Reverse the door opening direction
(on some models only)
Should it be necessary to reverse the direction
of the door opening from right to left:
1. remove the two screws of the lower hinge.
Class Room temperature
SN + 10°C to + 32°C
N + 16°C to + 32°C
ST + 16°C to + 38°C
T + 16°C to + 43°C
SN-ST + 10°C to + 38°C
SN-T + 10°C to + 43°C
Strong tightening
Risk of damage to the appliance
• Take care not to exert too much force when
tightening the screws, the side parts may
deform.
Loading ...
Loading ...