Loading ...
Loading ...
Loading ...
6-4 SERVICE DIAGNOSIS CHART
COMPLAINT POINTS TO BE CHECKED REMEDY
Cooling is • Is the power cord unplugged from the ouget? • Plug to the ouifet.
impossible. • Check if the power S/W is sat to OFF. • Set the switch to ON.
• Check if the fuse of power S/W is shotted. - Replace fuse.
• Measure the voltage of power outlet. • If voltage is low. correct wiring.
Cooling ability
is poor.
• Check if the sel is placed close to wall.
• Check if the set is placed close to stove, gas
cooker and direct rays.
• Is the ambient temperature high or
the room door closed?
I • Check if put in is hot.
• Did you open the door of the set too often
or check if the door is closed up?
- Check if the Control is set to WARM.
• Place the set with6_espece of about 10 cm (4incpes),
• Place the set apart from these heat
appliances
• Make the ambient temperature below.
• Put in foods after cooled down.
• Don't open the door too often and close
it firmly.
• Set the control to mld-positlon.
Foods in the • Rsfoed placed in cooling air outlet? • Place foods in high temperature section.
Refrigerator (Front Part)
are frozen. • Check if the Dial is set to COLD, • Set the dial to MID.
• Is the ambient temperature below 5"C? • Set the dial to WARM.
Dew or ice ° is liquid food stored? • Seal up liquid foods with wrap.
forms inside • Check if put in hot. • Put in foods after cooled down.
the set. • Did you open the door of the set too • Don't open the door too often and close
often or check if the door is closed, it firmly
Dew forms • Check if ambient temperature and humidity • Wipe dew with a dry cloth. This occurrence
in the Exterior Case, of surroumcling air are high, is solved naturally in low temperature and humidity,
• Is there gap in the door gasket? • Fill up the gap.
Abnormal • Is the set positioned in a firm and even place? • Adjust the Adjust Screw, and position
noise, in the firm place.
• Are any unnecessary objects set • Remove the objects.
in the back side of the set?
• Check if the Drip Tray is not firmly Fixed. - Fix it firmly on the odginal position.
• Check if the cover of mechanical room • Place the cover at the odginal position.
in below and front side is taken out.
Door does not • Check if the door packing is dirty - Clean the door packing.
close well, with filth such as juice.
• Is the set positioned in a firm and ever} place? • Position in the firm place and level the
Adjust Screw.
• Is too much food putted in the set? • Keep foods not to reach the door.
Ice and foods • Check if the inside of the set is dirly. * Clean the inside of the set.
smell unpleasant. • Did you keep fragrant foods without wrapping? - Wrap fragrant foods.
• It smells of plasfic. • The new products smells of plastic, but it
will go away after 1-2 weeks.
• In addition to the items described left, refer to the followings to solve the complaint.
/
Check if dew forms in |
F
the freezer.
Defrosting
is poor.
Replace the
Components of
defrosting circuit.
Cycle.CheckRefrigerating t
Check the
Thermistor
The cycle
isfaulty.
> Repair the cycle.
The operation of
the Thermistor is
poor.
Replace the
Thermistor.
-13_
Loading ...
Loading ...
Loading ...