Loading ...
Loading ...
Loading ...
To prevent personal injury, always turn the saw OFF and
disconnect the plug from source before changing blades
or making adjustments.
Pin-end type blades are thicker for stability and for faster
assembly. These blades are used whenever faster cutting
on a variety of materials and ¾-inch thickness or greater
are required. Use whenever less precision or thicker kerf
cutting is acceptable.
Note: When installing pin-end blades, the set screws
located onthe upper and lower blade holders should not
be over or under tightened.. The slot must be slightly
wider than the thickness of the blade. After the blade is
installed, the blade tension mechanism will keep the
pin-end in place.
PIN-END BLADE REMOVAL (FIG. J, K)
1. To remove the blade (1), loosen the tension by lifting
up the quick release tension lever (2) (Fig. J).
Fig. J
2. Remove the blade (1) from the upper (4) and lower (5)
blade holder by pulling forward to release, and lift the
blade through the access hole. (Fig. K)
Fig. K
4
CAUTION: In order to avoid uncontrollable lifting of the
workpiece, the teeth of the blade should always point
downward.
1. Install the blade (1) by inserting one end of it through
the access hole (6) or throat plate in the table, Hook
the lower blade pin in the pin recess in the lower
blade holder (5) and then the upper blade pin in the
upper blade holder (4) (Fig. L)
Fig. L
,
4
I 1
6
Check to see that the pins are properly located in the
upper (4) and the lower (5) blade holders and move
the table (7) to the 0° bevel position by unlocking the
bevel lock knob.
.
To tension the blade (1), lower the quick release
tension lever (2). Check the tension on the blade; if
tension is too tight, turn the lever, counterclockwise. If
tension is too loose, turn the lever clockwise (Fig. M).
Note: If the blade is over tensioned, the lever will be
difficult to lower and could result in damage to the
blade holder or arm assembly.
Fig. M
.
Tilt the table to a 45° angle and lock the bevel lock
knob to view lower blade holder (8) (Fig. K).
Note: Apply slight downward pressure on the upper
arm when removing the blade from the upper blade
holder.
Loading ...
Loading ...
Loading ...